0
What else can I help you with?
Where is throttle sensor on 91 buick regal?
It is mounted on the throttle shaft usually on the other side from the throttle cables. It has a three wire connector plugged into it.
Where is the camshaft sensor location 1997 buick?
Cam shaft sensor is located under the power steering pump on the block
Where is crankshaft position sensor located on a 1994 Buick Regal 3.8 and how do you replace it?
behind the crank shaft pulley. remove pulley and install new one make sure to replace it in the exact same spot it was before of you will tear up your new sensor
I have a Buick la Sabre that wont turn over?
Crank shaft sensor need replaced or cam shaft sensor
Where is the crank shaft sensor located in a Audi a4?
Where is the crank shaft sensor located in a Audi a6
How do you change a park neutral safety switch on a buick regal?
find the neutral safety switch which is commonly located somewhere on the interior of the car near the steering shaft or on the transmission
Why is the 89 Buick Lasbre cutting out and not starting?
check your cam shaft sensor
Where is Buick 3800 VSS sensor?
The VSS is located on the transmission bell housing, on the passenger side near the output of the drive shaft there will be a wiring harness plugged into it
Where is the Turbine Shaft Speed Sensor located on a 1998 Explorer?
The turbine shaft speed (TSS) sensor is located inside the automatic transmission.
1996 buick regal 3.8 engine shuts off while driving.?
I had the same problem check the crank shaft position sensor i payed maybe 25 bucks for one and its not all that hard to change with the right tools.
What is the function of the cam shaft sensor I have a 91 Buick Regal?
Older cars used a distributor to control the firing of each spark plug. The proper setting was mechanically set. The newer cars use a computer to do this. The computer uses a crankshaft sensor to know its position and a cam shaft sensor to know which piston gets the firing pulse. The failure of either one will result in the engine not starting.
Can you prime a oil pump for 85 Buick Regal?
You can prime the oil pump on an 85 Buick Regal by removing the distributor and inserting a priming rod onto the oil pump shaft. It can then be turned by hand or with a drill to distribute oil throughout the engine.
