0
Older cars used a distributor to control the firing of each spark plug. The proper setting was mechanically set. The newer cars use a computer to do this. The computer uses a crankshaft sensor to know its position and a cam shaft sensor to know which piston gets the firing pulse. The failure of either one will result in the engine not starting.
What else can I help you with?
Where is throttle sensor on 91 buick regal?
It is mounted on the throttle shaft usually on the other side from the throttle cables. It has a three wire connector plugged into it.
Where is the speed sensor located on a 1996 buick regal?
On a 1996 Buick Regal, the speed sensor is typically located on the transmission. Specifically, it is mounted on the side of the transmission case, near the output shaft. To access it, you may need to raise the vehicle and remove any undercarriage shields or components obstructing the sensor. Always consult a repair manual for detailed instructions specific to your vehicle.
I have a Buick la Sabre that wont turn over?
Crank shaft sensor need replaced or cam shaft sensor
Where is crankshaft position sensor located on a 1994 Buick Regal 3.8 and how do you replace it?
behind the crank shaft pulley. remove pulley and install new one make sure to replace it in the exact same spot it was before of you will tear up your new sensor
Why is the 89 Buick Lasbre cutting out and not starting?
check your cam shaft sensor
1996 buick regal 3.8 engine shuts off while driving.?
I had the same problem check the crank shaft position sensor i payed maybe 25 bucks for one and its not all that hard to change with the right tools.
Where is the cam shaft sensor located on 2012 Buick Regal 2.4?
On a 2012 Buick Regal with a 2.4L engine, the camshaft position sensor is typically located near the front of the engine, on the cylinder head, near the timing chain cover. It is often positioned on the intake side of the engine. To access it, you may need to remove any obstructing components such as the air intake or engine cover. Always refer to the vehicle's service manual for precise locations and instructions.
Can you prime a oil pump for 85 Buick Regal?
You can prime the oil pump on an 85 Buick Regal by removing the distributor and inserting a priming rod onto the oil pump shaft. It can then be turned by hand or with a drill to distribute oil throughout the engine.
Where is the camshaft sensor location 1997 buick?
Cam shaft sensor is located under the power steering pump on the block
Where is the cam shaft sensor on a 98 Buick Riviera supercharger?
RIGHT SIDE OF ENGINE NEAR CRANK PULLY
What cause my 96' buick regal's service egine soon light to luminate then motor died while in motion?
There are many reasons your check engine light could come on. If your motor died while driving you should check the rank shaft sensor module, alternator and catalytic converter.
How do you change a park neutral safety switch on a buick regal?
find the neutral safety switch which is commonly located somewhere on the interior of the car near the steering shaft or on the transmission
