answersLogoWhite

0

The neutral safety switch on a 1994 Plymouth Acclaim is typically located on the transmission, near the base where the shift linkage connects. To change it, first, disconnect the battery to ensure safety, then remove the wiring harness from the switch. You may need to unbolt the switch from the transmission, install the new switch in the same position, and reconnect the wiring harness before reattaching the battery. Always consult the vehicle's service manual for specific instructions and torque settings.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

How do you change wheel bearing on 1994 Plymouth acclaim?

how do you change rear wheel bearing in 1994 Plymouth acclaim


How do you change a heater core on a 1994 Plymouth Acclaim?

you have to remove the dash


How do you change The Alternator on a 93 Plymouth Acclaim?

Buy a replacement car!


How do you change the transmission filter in a 1993 Plymouth acclaim 4 cylinder?

You have to drain/remove the "transmission" oil pan to get access to the filter.


How do you change the ignition switch on a 1992 Plymouth acclaim?

on my '91 with tilt steering the ignition switch is located underneath the key, inside the steering column only three screws hold it on, but alotta torx hold that cover on.....have fun


How do you change heater core on a 1990 Plymouth acclaim?

This process could take up to 3 hours. The Heater core is best flushed if you are having problems with flow. Is this an option? F. Garay


How do you change the serpentine belt on a 1990 Plymouth Acclaim?

loosen the tensioner assenbly with a 1/2" drive ratchet or a serpentine belt tool and reinstall the belt according to the diagram under the hood


How do you change the front turn signal light in an 1989 Plymouth acclaim?

Buying discounted Eddie Bauer can be very difficult since they do not usually discount their product. You can find their main website at EddieBauer.com.


How do you change oil pump in a 93 Plymouth acclaim 2.5?

To change the oil pump in a 1993 Plymouth Acclaim with a 2.5L engine, first ensure the car is securely raised and supported. Drain the oil and remove the oil pan by unbolting it from the engine block. Next, detach the old oil pump from the engine, typically by removing a few bolts. Install the new oil pump, reattach the oil pan, and refill with fresh oil before starting the engine to check for leaks.


Were is the transmission neutral safety switch on a 1969 Plymouth road runner and how to change it?

The transmission neutral safety switch on a 1969 Plymouth Road Runner is typically located on the steering column or near the transmission itself, depending on the specific setup. To change it, first disconnect the battery to ensure safety, then remove the necessary components to access the switch. Unplug the wiring harness from the switch, remove the mounting screws, and install the new switch in reverse order. Finally, reconnect the battery and test the switch to ensure proper function.


How do you change wiper motor 1992 Plymouth Acclaim?

To change the wiper motor on a 1992 Plymouth Acclaim, first disconnect the negative battery terminal for safety. Remove the wiper arms by lifting the caps and unscrewing the nuts, then take off the wiper arms. Next, access the wiper motor by removing the panel under the windshield, disconnect the motor's electrical connector, and unbolt the motor from its mounting. Install the new motor by reversing these steps, ensuring everything is securely fastened before reattaching the battery.


How do you change driver side headlight on 1992 Plymouth acclaim?

To change the driver side headlight on a 1992 Plymouth Acclaim, first, open the hood and locate the headlight assembly. Remove the retaining clips or screws that hold the headlight in place, then gently pull the assembly forward. Disconnect the wiring harness from the back of the headlight bulb, replace the old bulb with a new one, and reassemble by reversing the steps. Make sure to secure everything tightly and test the new headlight before closing the hood.