You can purchase a constant control relay module for a 1998 Mercury Tracer from several sources. Online retailers like Amazon, eBay, or specialized automotive parts websites such as RockAuto or AutoZone often stock these parts. Additionally, local auto parts stores or junkyards may carry used or new modules. Always ensure to verify compatibility with your specific vehicle model before making a purchase.
If you mean the Constant Control Relay Module, it is located under the air filter.
ignition control module is located under the distributor cap
The relay control module on a 1997 Mercury Tracer is typically located in the engine compartment, near the battery or the fuse box. It may also be found on the driver's side, towards the rear of the engine bay. For precise identification, it's best to consult the vehicle's service manual or a repair guide.
ignition control module is under the distributor cap
The End Result
Mercury Tracer was created in 1987.
need timing marks for 97 mercury tracer
The P1131 code for a 1998 Mercury Tracer indicates a problem with the air-fuel mixture, specifically that the engine control module (ECM) has detected that the oxygen sensor is reporting a lean condition in the exhaust system. This can be caused by issues such as a vacuum leak, a malfunctioning fuel injector, or a faulty mass air flow sensor. Addressing the underlying cause is essential to ensure proper engine performance and emissions control.
Need to know where is the thermostat located on a 1996 mercury tracer.
Is a 1996 mercury tracer 1.9 a interference engine?
Need to know where is the thermostat located on a 1996 Mercury tracer.
1999 mercury tracer fuse panel diagram