It sounds like the blower motor resistor it is located on the firewall i had the same problem with mine not hard to fix part is around 20 dollars
I don't know---does it? Get literate!
Perhaps heat shield on catalytic converter?
Have the heater core flushed. It might be plugged up with corrosion and dirt.
Pull the gauge cluster out and use a low volt solder iron, and re-solder the points where it plugs in to the cluster, just heat it until the solder starts to melt.
Every vehicle gets hot to the touch, it doesnt mean that your over heating or anything... a Plymouth Voyager gets 195 Degrees. the heat is actually better for the invironment then when the engine is cold because the heat helps burn all gases and keeps it from the air.
On my 94 voyager with the 3.0L the cylinder numbers are stamped into the heat shield located under the spark plug boots - you won't see these numbers with the wires on, since it obscures the stamping. On my van sequence from Left to right is: Front 2-4-6, Rear 1-3-5.
Voyager 1 is powered by three radioisotope thermoelectric generators (RTGs) that convert heat released from the radioactive decay of plutonium-238 into electricity. This power source allows the spacecraft to operate its instruments and communicate with Earth, even in the extreme conditions of deep space. The RTGs provide a steady supply of power over long durations, enabling Voyager 1 to continue its mission well beyond its initial operational life.
you need to press them in.if you put your ball joints in the freezer overnight they will shrink.Then heat up your a- arm with a torch and use a jack to pop the frozen ball joints in
Voyager 1 uses radioisotope thermolectric batteries, powered by the heat generated from the decay of a radioactive substance. In this case, plutonium oxide.
I'm guessing you're referring to the temp sensor for the battery. It is on the front of the battery tray. It looks like a small plastic bulb with a wire running from the bottom of it.
The lowest temperature at which a heat pump can effectively operate is typically around 25 to 30 degrees Fahrenheit.
check your water...