0
It sounds like you have the misfortune of having an "automatic" seatbelt. You could have a bad sensor, you could have a bad motor, you could have a jammed track, you could simpy have a burned out fuse (if you're lucky). If you hear a grinding noise or the carrier jerks but won't move when the seatbelt is supposed to be going from closed to open or open to closed positions, you're sunk. That means that the seatbelt is jammed or has jumped the track....replacements for this kind of thing out of warranty are extremely expensive....lift up your hood ornament, slide another car under it, discard your previous car. If you don't hear any noise or the seatbelt carrier doesn't even try to move, you may simply have a burnt out fuse...go through your fuse box and do a bit of trial and error. If you're lucky, it'll start working again. If not, it could be a sensor (thoughtfully built into the track on Fords...see grinding above for a solution), it could be a burned out motor (same repair indicated), or it could be an electrical problem/broken wire....I don't have that kind of patience, maybe you do.
What else can I help you with?
How do I fix a Toyota Sienna driver's side seat belt that is stuck?
To fix a Toyota Sienna driver's side seat belt that is stuck, you might need to pull the entire belt out slowly until it is completely extended. Then, allow the belt to retract slowly.
How do you disable the seat belt alarm for the driver's side on a 2008 GMC Sierra?
Buckle your seat belt, works every time.
How do you remove driver side seat BELT?
To remove the driver side seat belt, first, ensure the vehicle is parked and the engine is off. Locate the seat belt retractor, usually mounted on the side of the seat or the floor. Use a suitable tool, often a socket wrench, to remove the bolts securing the retractor and the buckle to the vehicle. Once the bolts are removed, gently pull the seat belt out to detach it completely.
Is there a switch in the driver side seat belt that affects the air bag?
Yes
How do you get your driver side seat belt to unlock?
Well, have to click the botton to unlock it
To buy a replacement seat belt for a 1997 Subaru Outback Legacy Does it make a difference if the seat belt is specified as a left side or right side belt?
Yes it does: Driver & Passenger front seat belt sets are mechanically different & have separate part numbers.....
How do you fix a driver side seat belt light that blinks even when you are wearing your seat belt?
the receiver for the belt has a sensor. if it fails the light will continue to flash even though the belt is buckled. replace it!
How can you fix a front driver's side seat belt that will not retract on your 91 lumina?
replave retractor
Why would a 2003 Honda Civic driver's side seat belt light stay on even when belt is connected?
Check the connection at the floor behind the seat to see if it is disconnected.
Is it safer to have a seat belt on when you get t-boned on the drivers side?
No it is not statistics show that of all crashes into the drivers side of the car, the said driver has a 28% chance of surviving with a seat belt and 82% of living without one.
Where is the seatbelt fuse on a 91 Honda Accord?
I would like to know if anyone know where the seat belt FUSE for a 91 Honda accord is the left side works but the driver side doesnt work can anyone help me? The problem is in the control box that goes underneat each seat, you need to replace it.
How do you replace the driver side pushbutton seat belt buckle on a 1997 Toyota Previa?
To replace the driver side pushbutton seat belt buckle on a 1997 Toyota Previa, first, remove the plastic cover around the seat belt assembly by unscrewing any screws or clips. Disconnect the seat belt buckle from its mounting point by unbolting it and unplugging the electrical connector if equipped. Install the new buckle by reversing the removal steps, securing it firmly and ensuring the belt operates correctly. Finally, replace the plastic cover and test the seat belt functionality.
