answersLogoWhite

0

exhaust needs to exit the body of the vehicle so it doesn't enter the passenger compartment

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is an intermediate exhaust pipe?

An intermediate exhaust pipe generally refers to the pipe that comes directly off of the manifold, and to which the catalytic converter, or mid-tail pipe section is bolted /welded too. On newer cars and trucks, the intermediate pipe sometimes has a bendable section that looks like a scaled up version of a braided tube.


How much should you pay to get a mid section exhaust and CAT unit fitted to a 1995 Peugeot 106?

In august my 1999 106 pipe broke at front end i needed full catalyst and exhaust. Cost for catalyst and pipe was �75 and exhaust was �24 before vat and fitting


How do 1996 Subaru Outback exhaust parts connect?

In the 1996 Subaru Outback, the exhaust system typically connects through a series of flanges and clamps. The exhaust headers connect to the catalytic converter, which then leads to the mid-pipe. The mid-pipe is secured with hangers and connects to the rear muffler, allowing for proper exhaust flow and minimizing vibrations. Each section is designed for a tight fit to prevent leaks and ensure efficient operation.


What causes backfire from exhaust pipe?

Unburned fuel in the exhaust system causes the backfire from the exhaust pipe.


Where is catalytic converter on a 1998 mercury mystique?

In the exhaust pipe, near the engine.In the exhaust pipe, near the engine.


Where is a catalytic converter located on a 2005 Chrysler pacifica?

It is in the exhaust pipe on the back of the engine.It is in the exhaust pipe on the back of the engine.


Where is catalytic converter on 2008 Chrysler Town and Country?

In the exhaust pipe, at the back of the engine.In the exhaust pipe, at the back of the engine.


Why pipe in pipe is used in exhaust system?

To reduce the noise created by the exhaust gases.


How many O2 sensors are there in a 1995 Toyota Camry six cylinder?

should have 3. 1 on the front manifold, 1 on the rear manifold, and 1 on the mid pipe "center exhaust pipe"


Are tailpipe and exhaust pipe the same thing?

The tail pipe is part of the exhaust system.


Show a diagram of 1988 mustang exhaust system?

Well, all naturally aspirated vehicles have the same general components to an exhaust system. It starts with an exhaust manifold that attaches to the engine block. The manifold then attaches to a "mid-pipe". This "mid-pipe" is where the Catalytic Converters are housed. These Catalytic Converters control NoX gases and are the emission control device within the exhaust system. From there exhaust crosses over via an "X"pipe or "H"pipe(the X looks like an X and the H looks like an H) and enters into the mufflers. These mufflers can be chambered or straight through, the latter being the better performing of the two. Finally it leaves the mufflers out the tailpipes. A general diagram can be found here:http://www.americanmuscle.com/mustang-exhaust-buyers-guide.html


How to make exhaust louder?

is it possible to cut your exhaust pipe to make it louder is it possible to cut your exhaust pipe to make it louder