answersLogoWhite

0

the park tab is bent. it is a thick piece of metal that must be bent back slightly toward the wiper motor with a hammer or plyers.

I assume this issue started when there was snow/ice on the windshield?

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you reset the windshield wipers for a 1998 Oldsmobile Intrigue?

There is no "reset" in the wiper motor. If your wipers do not park, it is likely your wiper motor parking contact or cam is broken. Try running the wipers with the key in the "ON" position, then turn the wipers off using their switch while they are up on the windshield. They should park themselves at the bottom. The good news is a wiper motor is pretty cheap at a junkyard, and not too hard to replace.


How do you get the wipers to go down in a 2001 Intrigue that are stuck in the up position?

Refer to the link below. It'll take you to the answer elsewhere on this web site.


Can you fix your wipers from stopping in the middle of the window of a Oldsmobile Intrigue 2000?

Yes. I've done it. Costs no money, just time. There are several YouTube videos on how you do it. Basically there is a metal tab called a pawl atop the wiper motor. You take the plastic trim off by the wipers then you adjust this pawl so it catches properly and the wipers will park where they are supposed to. Common problems with GM & Olds. Look it up. Good videos online.


2000 Oldsmobile Intrigue and after an ice storm your windshield wipers come to rest in the service position. pointed straignt up when you shut them off How can you get them to rest in their normal pos?

Same thing happened to me on 1998 intrigue. Also in snowy and freezing conditions. The link here attributed the problem to water freezing in the Wiper moter assembly Maybe it will start working when it thaws out? [hr] Wrong. Your windshield wiper motor is mounted to a bracket that has a little metal tab on it that the crank arm assembly has to hit in order to park the wipers, in a lot of cases this park tab in either bent or broken, and if bent can be adjusted. This happens if the wipers encounter too much stress, such as trying to wipe when they are frozen in ice. The tab can be easily bent back, if you can get to the wiper motor.


How do you fix windshield wipers up on a 2000 Buick Regal that park in the up position?

Could be out of synk need to loosen and reset then tighten back up


If wiper stop up on my Oldsmobile intrigue 2002?

If your wipers were froze down or stuck down when you tried to use them. It maybe the wipers are designed so that the bolt which is fastened to the fire wall backs off. try tightening that bolt and see if they do not been working again! From LHZ


When you use your delay wipers on your 2002 Oldsmobile intrigue they stop in the left hand corner of your windshield they do not stop in the park position what is the problem and what is the fix?

The issue with your 2002 Oldsmobile Intrigue's wipers stopping in the wrong position is likely due to a faulty wiper motor or a misaligned wiper transmission. The park position is determined by the motor's internal circuitry, which may be malfunctioning. To fix this, you can either replace the wiper motor or check the linkage for proper alignment and operation. Additionally, checking the wiper control switch may help identify any electrical issues affecting the wiper's movement.


Your 1999 Olds Intrigue GX will not rev up past 3800 RPM in Park even though you have more gas pedal to use?

It has a rev limiter, it is supposed to do that in park or neutral.


Why won't the wipers go off on 95 Buick Park Avenue?

The wiper switch on the ParkAvenue could be bad. Or, the intermittent relay for the wipers could be stuck, causing the wipers to run.


What size windshield Wipers for Buick Park Avenue 1997?

22"


What if your 99 olds intrigue will not dispense washer fluid How do you determine if it is the pump motor or the switch?

If you push the fluid button and the wipers move then it is the pump


Wipers stay up?

The car wipers should not stay up but return to their original position. The wipers will stay up if the wiper motor, the wiper controller and the wiper linkage are faulty.