Bad switch? Bad motor? see if you are getting power to it Open wire usually found in door jamb area
Probably a bad switch in the drivers door.
Maybe its your driver-side window regulator that stopped working.
The switch is burned out. Replace it.
The Drivers Door Module or Passenger Door Module on a 2003 suburban is also known as the "window / door lock" switch. These modules are located on each respective door, i.e. driver side door or passenger side door. It is the module that has the door lock/unlock switch and window up/down switch. Hope this helps...
From my 07 manual:Start the engine. Push down and hold the driver's window switch until the window is fully open.Pull and hold the driver's window switch to close the window completely, then hold the switch for about 2 seconds.
Check to see if you are getting power to the motor if so window motor is defective Could be open wire usually in the door jamb area
If it is just the driver side window and button, more than not the master control switch needs to be replaced. It could also be the window moter or reg. Either way its around $100 if its just the switch that's bad.
There are several possible issues when the window on just one side stops working. The most likely is a bad switch. Other possibilities are that the window motor has gone out or that there is a problem with the wiring.
Usually this problem is caused because the driver side power window switch is not working because that's where the current is supplied to the other window swithces
Both window switch on the front door will lower the window, the problem is that both switch will not raise the window back up to its close position and also the master window switch on the Driver's side will not operate all the time nor will the master door lock on the driver's side lock the passenger side door. On several ocasion the driver's side window switch lowered it's window and it would'nt raise the window back up unless after quite a few minutes playing with the window switch, opening the door, etc.
If your driver's side window goes down halfway and gets stuck in a 1999 Chevy Suburban, the motor could be failing. It could also indicate the window is off the track.
Often the plug in connector at the drivers side switch can becaome loose and break the connection. Remove the switch and check this.