0
Yes. You will have to buy adaptive motor mounts in order to install the 350. Your best bet is to get a newer model (1985 and newer) 350 with the oil dipstick on the passenger side of the engine. You can find motor mounts on eBay, but be careful, they are sometimes thin and weak. Advance adapters has one of the thickest sets available. There is also a guy in Crystal Springs, Mississippi, Joe Rocher, who makes the mounts. His slightly move the engine to the passenger side so that your steering shaft has easier clearance. I have converted a few trucks with everything from a 4 cylinder, 2.8 V6 and the 4.3 V6 to small block Chevy's. With the newer model engine, you can use the low performance exhaust manifolds for a 305 and they will clear your frame, and give you leak free exhaust.
If you need any more information on this you can email me at bonnerdean@Yahoo.com.
What else can I help you with?
Will a 350 fit in your gmc sonoma with a 2.5 in it?
yes, visit www.s10v8.com for more info.
What is 43 percent of 350?
43% of 350= 43% * 350= 0.43 * 350= 150.5
What veical has 16 rims that fit 1999 sonoma?
The vehicle with 16 rims that can fit the 1999 Sonoma is Chevrolet siverado.5stud 4.75 ??? The vehicle with 16 rims that can fit 1999 Sonoma is a Toyota truck.
What is bolt pattern for 1994 2.2 GM Sonoma?
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4
Will a fuel tank out of a 01 Sonoma fit on a 94 sonoma?
this might fit , you will have to see where the vent port is , also where the lines and filler neck connects if they are the same
Will a 4.3l out of a 99 jimmy fit in a 98 sonoma?
yes............!
Will a speedometer out of a 2001 F-350 fit a 2000 F-350?
Yes, it will fit
Will a 1985 350 distributor fit in a 1969 350 motor?
YES it will fit right in.
Will a 1993 GMC Sonoma plow fit on a 1994 GMC 1500?
no
Will a 350 chev fit in a 1995 gmc sonoma and what do you need to do this?
yes it will fit. you will have to make your motor mounts or try to find someone that makes them. I think you will need a mini high torque starter and if you have a 4.3 then the transmission will bolt up. I am not sure this is all you will need, but it is the things I know you will need.
What s10 transmission will fit a 350?
If the S-10 was equiped with a 4.3 liter engine the transmission will probably fit the 350. The transmission used with the 2.8 liter engine WILL NOT fit the 350 engine.
How many times does 8 go into 350?
To find out how many times 8 goes into 350, you divide 350 by 8. This calculation gives you 43.75, meaning 8 goes into 350 a total of 43 full times, with a remainder. Therefore, 8 goes into 350 a total of 43 times.
