In a 1971 Dodge Dart, gas vent tubes typically connect to the fuel tank and the charcoal canister as part of the evaporative emission control system. The vent tube allows fuel vapors to escape from the tank and directs them to the charcoal canister, where they are stored until they can be burned in the engine. This setup helps prevent fuel vapor release into the atmosphere. Additionally, the vent tube may connect to the filler neck to allow air to escape as fuel is added.
no, the dart was never a twister model but the dodge demon made that model in 1971.
yes you should be able to make it fit.
right above the dampener.
28 to 32 degrees on the dwell, if you set it at 30 you will be perfect.
If it's a 2 door it is a collectible car as the 4 doors are not in as much demand.
no, the dart was never a twister model but the dodge demon made that model in 1971.
If they measure the same width it should fit.
yes you should be able to make it fit.
right above the dampener.
28 to 32 degrees on the dwell, if you set it at 30 you will be perfect.
Dodge Dart was created in 1960.
1970-74 Plymouth barracuda 1971-76 dodge demon/duster/ Dart sport
If it's a 2 door it is a collectible car as the 4 doors are not in as much demand.
The 2013 Dodge Dart has 16 valves.
The 2014 Dodge Dart has 16 valves.
either change the k-frame or use motor plates to mount the engine.
The 2014 Dodge Dart is a gas-powered vehicle.