0
98 ford explorer sport you've replaced the fuel pump and crank sensor and it still won't start you can spray gas in the intake and it will run for a few seconds any ideas?
Wiki User
∙ 14y ago
I'm not a mechanic / technician but if you can spray gas in the intake and it runs for
a few seconds it sounds like you are getting spark but you are still not getting gas
So listing the reasons I can think of why you wouldn't be getting gas :
- no gas in tank ( sorry ! I just start with the basics )
- fuel line still doesn't have fuel in it ( cycle the key between the run and off positions a few times )
- fuel pump not running ( inertia switch tripped , bad fuse , bad fuel pump relay , bad fuel pump , bad electrical connection )
- clogged fuel filter ( do you have fuel pressure at the engine test port ? )
- anybody else have any ideas ?
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is cam sensor 302?
There was only a visible cam sensor on '98-2001 Explorer 302's. If you have a distributor, your cam sensor is in the distributor. If you don't have a distributor, it is where the distributor used to be on the front of the intake manifold.
Where is iat sensor for a 2007 mustang gt?
The IAT sensor (Intake Air Temperature) is an integral part of the Mass Air Flow sensor.If the IAT sensor must be replaced,you must replace the MAF sensor
When Lincoln Town Cars intake manifold has been replaced now it wont even crank over battery getting 12 volts any ideas was running fine before?
The reason a Lincoln Town Car might not start after the intake manifold was replaced could be that the MAP (Manifold Absolute Pressure) sensor was not installed properly after the manifold was replaced. The computer might also need to be reset.
1996 transam starts runs a couple seconds then shuts off replaced fuel pump same thing.?
Check the connector to the air flow sensor ( should be at or near the air cleaner), it could also be the sensor itself
What does mean if the knock sensor caused the check engine warning?
your knock sensor could need to be replaced
Explorer engine oil change soon light stays on?
If an Explorer engine oil change soon light stays on, the sensor needs replaced. The sensor may also need reset by holding the button down for five seconds.
Where is maf sensor on a 2003 ford explorer?
it is in the air intake canister
Where is the Intake Air Temperature sensor located on a 2001 ford explorer sport?
The intake air temperature sensor is connected to the mass airflow sensor as one unit, it's at the beginning of the air intake tube just after the air cleaner. The sensor with six wires running out of it
Where is the IAT sensor on a 2000 Ford Explorer XLT with the 4.0 V6 SOHC Its not on the intake tube.?
Look for a wiring harness and connector, that connects to the air intake tube. That is where your intake air temperature sensor is located
Where is the air intake sensor on a 1996 ford explorer?
In the big rubber air intake tube , not too far from the throttle body
Does the Ford Explorer- 2000 have an iat sensor?
On a 2000 Ford Explorer : YES ( the intake air temperature sensor / air charge temperature sensor should be in the rear side of the big rubber engine air intake tube , located between the engine air filter and the throttle body )
Where is the IAT sensor located on a 1998 Ford Explorer 5.0L?
The 1998 Ford Explorer 5.0 liter engine IAT sensor is located between the engine and the air filter box. The IAT sensor will be on the air intake hose.
Where is the IAT sensor on a 1994 Ford Explorer if it's not on the air plenum?
On your 1994 Ford Explorer , I believe the intake air temperature sensor is mounted in the side of your upper intake manifold , not too far from the idle air control valve , as you look along the side of the upper intake manifold towards the firewall (Helpfull)
Where is the mass air flow sensor at on a 98 Ford Explorer?
On a 1998 Ford Explorer : The Mass Air Flow Sensor is between the engine air filter and the big engine air intake tube
Why does 1987 wrangler 2.5 start and die seconds after?
That would probably be the intake maf sensor or intake air sensor, if it doesn't detect air flow it shuts off the fuel
Where is the iat on a 2007 Chevy silverado new body?
The Intake Air Temp sensor is integral to the Mass Airflow Sensor (MAF). It cannot be replaced seperately. The MAF sensor would need to be replaced if you are trying to replace the IAT sensor. - TechJK -----------------------------------
Where Is the Mass Air Flow sensor on 2002 Explorer?
On a 2002 Ford Explorer : The Mass Air Flow sensor is between the top of the engine air filter housing and the big engine air intake tube
