Oil paint ? are you refering to an "oil-based" paint or artist's oil's? you can add "japan drier" to both, and it only takes a little bit .usally "unfininished plywood would "suck up" paint,as quick as you applied it.Remember you have to stir it up real good.
If the plywood is for an indoor craft project: Water base enamel. For outdoors: Oil base with UV inhibitors Key is using the proper base or primer or undercoating. Follow paint manufacturer's recommendation.
Yes, enamel paint will go over flat paint.
you can paint over latex paint with latex enamel.
yes
Get some paint brush, a paint and a silver foil first ... Second, dip the paint brush to paint and brush it to the foil ! and i think that's how you do it ! :) wew ..
Yep.
You need to rough up the surface of the oil paint with sand paper or a light coat of stripper.
Marine grade plywood and treated plywood aren't the same thing. Marine grade plywood has special glues and woods that will withstand constant immersion in water. Treated plywood is regular plywood that has been run through a pressure treating cycle. Paint will stick to treated plywood if you make sure to let it dry for a few months before you paint.
plywood
Water based paint does very well on plywood. The finish depends on the type of paint.
Yes. Simply spackle the plywood or roll on plaster with a paint roller. Let it dry, sand if you like, and then paint.
Black spray paint because it absorbs while tin foil reflects. So you know that the black spray paint will get hotter/ warmer faster.
Oil paint ? are you refering to an "oil-based" paint or artist's oil's? you can add "japan drier" to both, and it only takes a little bit .usally "unfininished plywood would "suck up" paint,as quick as you applied it.Remember you have to stir it up real good.
You couldn't tile directly over a plywood sub-floor because over time, the wood will be expanding. There are products you can use in between the plywood and tiles to keep them in place such as cement backer board.
Clean via power spray, scrape and sand, prime and paint.
You would be better of removing the plywood floor completely - and tiling over the original surface.