0
Does the battery on the remote need to be good for car to start?
Wiki User
∙ 13y ago
If you are using it to turn on the car a good battery would help.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Do you need to reprogram the remote to a cool start car starter after replacing the battery?
No
Remote car starter stopped working after a new battery was installed How do you get it to work again?
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
Looking for a wiring diagram for a remote start the name of it is command start my 93 Chevrolet truck will not start with remote?
hello i need to know what wires i need to hook up for my aftermart remote start in in 94 Chevy s-10 truck with a 2.2 motor
Battery went dead on your del sol jumped it but now it wont start?
You need a new battery.
97 explorer clicks but wont start?
You need to charge your battery or get a jump. Replace the battery or have it checked because it is dead.
Does remote start need a new battery in the starter?
There is no battery in the starter.
Do you need to reprogram the remote to a cool start car starter after replacing the battery?
No
Why does auto page remote starter will sometimes not start vehicle?
maybe you need a new battery in your remote control
How to reset a car auto start?
the battery died in my remote. After replacing it the auto start will not work. What are the steps I need to take to reprogram it??
How do you replace the battery on a GM remote key fob AB01502T?
hopefully this is what you need . The battery on the remote can be replaced with a cell battery number cr2032 there is only one little screw on the remote you will need a precision screwdriver. Dollar tree actually carry a little set (cheap but will do) open the remote battery pushes out quite easily you can use the same screw driver to help push it out. then replace with new battery. now walk up to car and hit the unlock button atleast four times until it unlocks the door. you need to do this in order for the car to recognize that remote and key. Good luck.
Remote car starter stopped working after a new battery was installed How do you get it to work again?
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
How do replace a battery in remote car starter?
I need three batteries for remote starters where do I purchase them? Can I have them shipped
Keyless entry to2006 tacoma wont work after replacing the remote battery?
How long was remote left without battery. Information stored may be lost if the new battery is not in place fairly quickly. You may need to have your remote recoded.
Why a 1980 f150 4.9 wont start and the battery is good but will start if boosted?
I assume you had the battery properly tested under load. Its starts and runs when jump started so that tells me assuming the battery is in fact good that the battery cable connections to the battery are bad and need cleaning.
1999 RX 300 remote sensor - Where is it and does it need cleaned - Remote lockunlock intermittent Not battery?
You need a new door lock actuator
Why wont my 92 Chevy lumina 3.1 start?
Try getting a jump start. Could be a bad battery. If your battery is good, then you will need to get a new starter. It may be the Starter or the battery make be dead,
Does a 1983 Honda Xl250 need a battery to start?
No, a 1983 Honda Xl250 does not need a battery to start.
