On some cars you open the hood, and the light socket will be right on the inside behind the fixture itself. A quarter turn counter clockwise and pull will remove the socket. Then push in while turning a quarter turn counter clockwise again will release the bulb, or on newer ones, you just pull them out as they are the spade type. On some cars you will have screws holding the lens assembly in, and it would have to be removed to replace the bulb. Then still on others, you would reach underneath the bumper.
Turn on the hazard switch (emergency blinkers). You should hear it under the dashboard on the drivers side. The emergency blinker and turn signal are each controlled by a different relay but the relays look alike. Once you've located the emergency blinker relay, the turn signal relay is nearby.
check your fuses first, then check your bulbs and then your relay.
The 2001 Kia signal flasher relay switch can be found beneath the drivers side dashboard. The signal flasher relay switch will be above the brake pedal.
The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
1986 Pontiac Fiero turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
under dash drivers side mounted above the brake pedal
under the dash
Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.
There is no relay. The flasher in under the dash on the left of the steering column
in the fuse pannel located on the drivers side of the dash facing the door.
It is directly above the brake pedal mounted to the right of the steering column. Under the drivers side of the dashboard, look for a round silver disc that has prongs on the back .It is attached to the fuse panel.
Turn on the hazard switch (emergency blinkers). You should hear it under the dashboard on the drivers side. The emergency blinker and turn signal are each controlled by a different relay but the relays look alike. Once you've located the emergency blinker relay, the turn signal relay is nearby.
The 1991 Pontiac turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.
check your fuses first, then check your bulbs and then your relay.
You can change the front turn signal, on your 2006 Pontiac Montana, by removing the retaining nuts. Remove the wiring harness. The turn signal will come free. Reverse the process to install the new turn signal.
take the wheel well out first then reach in and turn bulb socket
pictures of how to change front signal bulbs on a 2004 grand prix pontiac