answersLogoWhite

0

This is how to remove it..... fitting is same but in reverse.

First, remove the battery, taking off the negative connection first.

Remove the 4 bolts holding the battery tray in place (13mm socket)

Underneath the car, at the back of the engine, remove the pozi drive screw holding the LT lead to the back of the solenoid, remove the top nut connecting the thick cable to the back of solenoid (I found this easier to do once the starter was hanging loose)

Back above the engine, loosen the 19mm bolt that holds the starter motor to the gearbox (it's a tight squeeze to get access to it)

Then back underneath, loosen the bottom starter motor bolt (14mm)

Back above, remove the 19mm bolt, underneath again and while supporting the starter, remove the 14mm bolt.

The starter can then be jiggled about to remove it completely.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How much to fit ball joint on vauxhall combo van?

possibly $0.00c go figure!


How do you fit a vauxhall combo wing mirror?

unscrew the old one and screw on the new one . . Easy!


How do you fit a speedometer cable on vauxhall combo?

speedo connected to gearbox and connected to other end not brken but not working


Does mk2 golf 1.6 starter motor fit mk2 golf gti?

Yes, a starter motor from a 1.6 will fit a 1.8 and vice versa.


Fit a starter motor on vectra cdti 55?

Yes, a starter motor can be placed in a Vectra CDTI 55.


How difficult is it to Fit a starter motor for peugeot 306?

i dont know how to fit a stater moter!!


Will a sbc 350 starter motor fit a sbc 400?

Yes.


How do you fit a starter motor on a fiat brava 1.2 16v?

To fit a starter motor on a Fiat Brava 1.2 16v, first ensure the vehicle is safely lifted and secured. Disconnect the battery and locate the starter motor at the transmission housing. Remove the bolts securing the old starter motor, disconnect the wiring, and then install the new starter by reversing the process—connecting the wiring first and securing it with bolts. Finally, reconnect the battery and test the starter to ensure proper operation.


How do you fit a starter motor on a diesel?

to fit a starter motor it is normally held in by 3 maybe 4 bolts dependant on what car it is. these bolts are normally easily found when the starter motor is found which will be located either on the back or the front of the engine. attached to the gearbox. there is aso the main feed wire connected to the starter which must also be removed but always remember to disconnect the battery terminals before removing the starter.


Will the starter motor from a Nissan CD20T fit a CD20 ok?

yes without a problem


How do you fit petrol cap door on vauxhall meriva?

how do I fit a petrol flap to a vauxhall meriva


How long does it take to fit a concentic valvein a vauxhall astra?

How long does it take to fit a concentic valve in a vauxhall astra