0
How do you know it's not the gasket and just not the sensor out?
Wiki User
∙ 10y ago
If you think you have a vacuum leak because of a bad gasket, spray the area with carb cleaner while the engine is running. If you have a vacuum leak the engine idle speed will change when you hit the right spot.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you change a turbo on navara?
Remove the oil line from the Turbo. Remove the temperature sensor from the Turbo. Remove the Turbo retaining nuts. Replace the old Turbo gasket with a new gasket. Reverse the process to install the new Turbo.
How do you replace the ABS differential sensor on a 1995 3.9L Dodge Dakota?
If you know it is bad, just unbolt the hold down and pull it out.
What happens with blown manifold exhaust gasket?
if it is just a blown exhaust manifold gasket it can ruin your valves, so replace it correctly and make sure everything is clean before putting on the new gasket
What are the risks of just changing the head gasket without getting the whole head redone on a 1994 Pontiac Grand Am SE I mean?
No risk just make sure head is not warped before replacing gasket Is this a quad 4 motor????????????????????
Does a knock sensor ECM error mean that sensor is bad or that the sensor is just reporting a knock in the engine?
The sensor is bad. A properly-functioning knock sensor allows the ECM to advance timing until it senses a knock. It then retards timing until the knock just barely goes away allowing for optimal gas mileage.
Why doesn't a warning light show if you have a blown head gasket on vectra c 04?
Because there's no sensor on a head gasket its just plastic
Does head gasket repair affect throttle sensor?
No.
Can a bad crank sensor cause blown head gasket?
No
Does the valve cover gasket have anything to do with the camshaft sensor?
Code PO342, Camshaft sensor came up, mechanic says replacing the balve cover gasket will fix this. Does that sound right?
How do you know if it is your oxygen sensor or your exhaust manifold gasket causing the check engine light to come on?
u need to know what codes its reading go to auto zone and have it read for free
Can water cause the oil sensor switch to malfunction had the head gasket done because water was getting in the oil car is fine know but know the oil sensor switch do not work correctly.?
It is possible so just replace the oil pressure sending unit to be sure. If your oil pressure is low and you drove the car around for any period of time with a blown head gasket you may have internal engine damage which can cause low oil pressure. You may have destroyed this engine and it may need an overhaul.
Instructions of install cam shaft sensor 97 eclipse 2.4?
Camshaft position sensor aren't hard to replace, just remove the bolt(most on have 1) and disconnect the wire. Reinstall the new one(just remember to replace the o-ring/gasket).
What would make a car hesitate and choke?
there are a number of things that could cause this. water in the gas, bad oxygen sensor, blown or bad head gasket, cloged air filter. you would just have to take it to a mechanic for them to check out to actually know what is wrong
How do you install a new gasket seal?
we need to know which gasket your talking about. Gasket in a condesate pump
Does the gasket for a egr valve need any gasket sealant?
no gasket sealant needed. Just original gasket is fine.
What is the sensor directly above the oil pan gasket next to the starter in my Chevy 350?
What year, and application? NEW ANSWER: That would be the knock sensor,
1998 dodge neon has oil leaking from passenger side of car were can this be coming from doesn' t appear to be coming from filter pan sensor or gaskets what else should we check?
camshaft position sensor gasket or head gasket both likely
