take front grill out, stick your hand in there and feel around until you feel the cable get a pair of needle nose pliers and pull on the cable it should pop right open.
The fuel cap release, for a Chevrolet Tahoe, is located on the floor next to the drivers seat. Pull the lever up to release the cap.
one lever in a bathroom is a toilet lever hope that helps:)
Lever House was created in 1952.
It is probably a problem with switch ( the lever ) Or in the wiring (broken wire somewhere)
A lever in a bathroom can flush your toilet or open a faucet.
You can open a hood on a 1995 Chrysler LeBaron convertible gtc from the outside if your lever is broken. All you have to do is get a pair of vise grips and pull the cable which will release the hood.
To open the hood on the 2000 Beetle if the hood release lever is broken inside the car, you can remove the glove compartment of the vehicle and find the release cable inside the dashboard. Pull the cable to open the hood. You will then need to replace the hood release lever.?æ
Next to impossible. A new release lever will need to be installed. Take it to the Toyota dealer ... they built it, they know how to repair it.
There is a small plug on the inside panel, remove it and there is a release lever inside the door.
At one time, they ALL were on the outside. Starting in the 190's, they were grradually changed over to an inside release to secure access to the engine and battery.
These cars have hoods that open on the windshield side with the hinge toward the bumper. Apparently I'm not the only one having this problem Generally, cars have a manual hood release latch just inside the grill of the car, under the hood.
If it is just the plastic handle broken, behind that is the cable that opens the hood. Just grab the cable with a pair of pliers and pull. You can probably just replace the inside handle and not have to run a new cable.
The problem is that the inside door handle is broken. Although the inside door handle needs replacement you can still open the door by pulling on the lock lever above the handle.
There is a small metal lever back by where the foot lever rotates (normally the release cable is hooked into it) Pull it forward and the foot lever will release - careful it doesn't smack you in the face!
Its very easy. You can look by the brake pedal and there is a release lever with a hole in it. just pull the lever towards you and it will release.
hold the lever. Push outside !
Probably a broken cable.