0
What else can I help you with?
Where is the starter on a 1998 Chevy Lumina?
You don't. Starter fluid is a really good way to damage the motor inside because it created far more pressure than the motor is designed for. It's best to find and fix the problem rather than use the fluid. You would put starter fluid in the gas tank.
How do you install a starter on a 1992 Ford Thunderbird sc?
You need a manual to acquaint you with your car and tell you how it is done. Get one from DISCOUNTAUTOREPAIRMANUALS.COM. The manual with really help... but it isn't that difficult. The starter is located underneath the engine about in the middle. It's best if you hoist up the car and use jack stands for safety. Remove battery ground (negative terminal) cable. There are two 13mm bolts that hold the starter motor to the engine. You may need to remove an oxygen sensor if it's in your way. Otherwise, remove starter cable (red) from the starter motor and then remove two bolts. To install, repeat the following in reverse order. Torque specs on the starter motor bolts is 20-27 Nm (15-20 lb-ft), and starter motor cable 8-12.4 Nm (70-110 lb-in).
Why makes the starter on 1998 silverado engage when the positive cable is connected and the key is not in the ignition?
Did you put a starter on it ? If so, Then you have put the starter wires in the wrong place are you have the big battery wire touching the small wire that goes to the starter. Recheck the wiring on the starter.
You have put two starters on a 1989 Nissan truck in the last month What could make the starters go bad?
This is a general that will cover most vehicles. I have found the major cause of repeat starter motor failiure is caused by the motor being energised when the engine is running. The most common cause of this problem is a faulty ignition switch, this causes current to flow to the starter motor when the engine is running. The way to test this is when the engine is running use a test light connected from the small terminal on the starter soleonoid to earth the test light should not light Good luck
How do you do a chain adjustment on a Bombardier Rally 200?
put a new chain on it
How do you ring out an electric motor?
Put the wires in your but!
Can you put a ford 302 starter on a 2.3 ford motor?
no
What happens if you connect a starter motor backwards?
By connect a starter motor backwards I assume you mean put the negative cable where the positive cable would go and then put the positive cable to the negative connection. In that case the starter motor should run backwards. That might be a handy thing to do if you are using a starter motor to power something else such as a winch or maybe a pump.
How do you make an electric shield?
# get these materials for a 3 x 3 foot shield : 4 metal bars(3 foot),a electric motor and 100 foot of electric wires. # cut a little piece out of the wire each inch. # put the 4 bars together. # put the wire and the bars together. # load up the motor and put it on the wire# put the motor on. # the motor explodes, that means you are stupid
How 2 build a chainsaw bicycle?
buy a cheap bike then buy a good chain saw then take the chain saw apart then stay with the motor and get the chain of the bike and conect it to the motor then put gas in the motor then have fun.JUST BE CAREful
Where do you locate the starter motor on a Rover 414?
To locate the starter motor you open the bonnet then look between the radiator and the gearbox you will then see the starter motor the live wire coming from the battery goes to the starter motor so just follow that. The starter motor is held into the gearbox with 3 bolts and a bracket at the other end. This bracket needs removing before you undo the 3 main bolts as the starter wont come off with this bracket on.Make sure you know where the wires go when you put it back together
How to remove starter motor?
To remove the starter motor, disconnect the battery first. Take a picture, if possible, so that the new starter can be put back in place the same as the old one was. Disconnect the wires and remove the starter bolts. Remove the starter and replace with a new one. Hook up the wires and the battery.
How do you turn on hydro 4wd on john deere 2130?
Type your answer here... put your dick in the starter motor
How do gopeds work?
A go-ped is simply a stand up scooter with a motor, be it gas or electric. In the case of a gas scooter, the motor has to be running, throttle engages and power is put to the rear wheel via chain or belt, thus moving forward, at your own risk of course, lol.
Is it possible to put an electric starter on a 1959 harley panhead?
www.motorcycle-parts.are-us.com sells a complete kit to put an electric starter on your 1959 Panhead, In fact, we offer an electric starter kit for putting an electric starter on either Panheads, or Knuckleheads, and you can even keep the original tin primaries. Check It Out!!! www.motorcycle-parts.are-us.com/mm5/merchant.mvc?Screen=PROD&Store_Code=areus&Product_Code=ttc_pan-knuckle_electric-start_belt_drive_kit&Category_Code=Electric-Starters Very nice setup, Made in the USA!! sales@motorcycle-parts.are-us.com http://www.motorcycle-parts.are-us.com
How do you change the timing chain on a toyota 3y motor?
To change the timing chain on a Toyota motor, you need to first get a new timing chain. From there, take the old one off. You may have to remove things in the engine to do this. Put the new one on, looping it around.
How do you replace starter motor on 1999 jetta?
disconnected the batteris - disconnet the wiring on starter motor,make not of the cables remove the two bolts securing the start to the car, installation is reverse Disconnect and REMOVE the battery. This allows you to get to the wires on the starter much easier. Then remove starter. Be sure to get the small bearing out of the housing and replace it. A new one should come with the starter, but if it does not, get one and put it in.
