some where along the parking brake cable is an adjusting nut. Loosen the nut and then lock it back in place with the other nut.
If you mean the Flat tire indicator button, it's next to the parking brake.
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
If it still doesn't burn, check the ground of the light assy.
Hi, either you get it all reset, or you can get a code to bypass the immobilser. Its put in via the door lock thing on the dash and you count the immobilizer light flashes. You can buy the code from Renault, or you can get a small programme off the net which will get the code for you, I did this and it worked fine, and there is no limit to how many times you can use the code.
Somehow you set off the antitheft system. In order to reset it you have to unlock the drivers door with the key.
To reset the parking brake on a Renault Scenic, first ensure the vehicle is on a level surface and the ignition is on. Press the brake pedal and then pull the parking brake switch up to engage it. Next, keep the brake pedal pressed, and then push the switch down to release the parking brake. If the warning light remains on, consult the vehicle's manual or a professional, as there may be an underlying issue.
Trip to the stealers Only..............
To reset the "Check Parking Brake" message on a Renault Scenic, first ensure that the parking brake is fully engaged and then disengaged. Next, turn the ignition on without starting the engine and press the brake pedal. Finally, navigate to the vehicle settings on the dashboard display and select the option to reset warnings or service messages. If the message persists, it may indicate a more serious issue that requires professional inspection.
You can't reset the parking light - It shows you have a fault at that time - Cure the fault and the light will go out - I have a problem with mine - I have an intermittent fault the light only comes on when the parking brake is faulty - most of the time the lights out
The handle is there to release the electric parking brake if it fails to release and sticks on. Lift the flap in the floor panel and pull the handle upwards, this should release the parking brake. You can then Drive the vehicle but note NO HANDBRAKE to park leave in gear with foot brake on before turning off the ignition. Otherwise you will have a runaway!!! Oh estimated cost to reset it all £500.00 or spondooolics!!!!!! NASTY Mr RENAULT!!!!
reset brake wear display on dash board after changed rear disk brake ?
To reset the brake wear indicator on a 2011 Renault Master, first, turn on the ignition without starting the engine. Then, press and hold the brake pedal while simultaneously pressing the gas pedal. After a few seconds, release both pedals. This should reset the brake wear indicator, and the warning light should turn off. If the light remains on, consider checking the brake system for any issues.
It has to be reset by a Renault dealer (or anyone with a Renault Clip diagnostic).
On a B6 Passat with EPB (Electric Park Brake), this can only be done using a diagnostic tool such as VCDS or similar.
The Fuel Pump reset is behind the parking brake release knob.
Make sue brake fluid reservoir at top of master cylinder is filled to proper levelMake sure parking brake is fully releasedAnswerMake sue brake fluid reservoir at top of master cylinder is filled to proper level Make sure parking brake is fully released
Put key in ignition in the second position and open the driver door. should reset in about 10sec.(assuming that you've changed the brake pad wear sensor)