There are two air bleed valves on this model. One is located on the thermostat housing and it is a small brass screw with a screwdriver slot and ridged edges. The second is located on the coolant bypass tube. It is the black metal tube that runs along the valve cover from the water pum to underneath the intake body. It is about the size of a pack of life savers and stands vertically. It has a brass screw at the top and is (I believe) an 8mm. This is not slotted and is an octagon.
If you are having any problem with the heat regulation such as losing water and a problem with a varying temp that climbs and drops or just climbs. There is a known problem with the lower intake manifold valve cover gasket. that can let coolant leak out slowly. There is anew gasket kit that is available that corrects this problem.
Hi, this is a common problem with subaru's - you need to get the cooling system pressure bled - i.e there is air in your cooling system.
Check the relay.
Loosen Nadar pin and move, BUT DO NOT REMOVE
Look at the rear of the radiator approx. 1/3 down from the top
What I believe your trying to ask is how to remove the drive shaft? If so than all you need is to remove the
Auto Zone or Advance Auto Stores will do it for you free.
The 2000 Chevy Cavalier cooling fan shroud is held in place with 10 retaining bolts. Remove the retaining bolts and the cooling fan shroud will come off.
There is a a cooling system from articair that us considered a minture air conditor for undr 2000.
Drain the water from the cooling system. Remove the water hose from the water pump. Remove the water pump retaining bolts. Remove the water pump. Reverse the process to install the new water pump.
It's in front of driver wheel! It is necessary to remove a forward casing (it is attached to a wing) there it will be! It near to system of preliminary cooling.
Remove the alternator belt on your 2000 Oldsmobile. Disconnect the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Put the new alternator on and reverse the process.
When you service the cooling system.
Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?
I have a 2000 Silhouette also and I purchased my manual at an auto parts store. It has schematics for 90% of the van. I don't want to get into trouble for plugging a store so email me denwa60@live.com
A free diagram, of a 2000 Dodge cooling system, can be obtained from most Dodge dealerships. Many auto-parts stores will make the diagram available.
Remove the under hood fuse box, then remove the fender brace. This give acess to the battery, which can be disconnected and lifted out. It is not as difficult as it may sound.
Crawl under the car and look up at the exhaust system. You will see the converter.