answersLogoWhite

0

You might try this website.

http://www.toyotaownersonline.com/parts-service/diy.html

User Avatar

Wiki User

16y ago

What else can I help you with?

Continue Learning about Art & Architecture

What holds the headlights?

In sealed beam headlight units, the lamp is held in by a metal ring bolted around the front edge. In halogen lamp units, the lamp is held in the back of the reflector by means if a locking ring.


How do you replace the headlight bulb located on a 2001 Chevy Prizm?

The bulb assembly needs to be removed from the front of the vehicle. Open the hood, and you will see that the entire plastic headlight assembly is held in place by a few hex head screws. Once these are removed the entire assembly can be lifted out, giving you access to the lamp socket. Replace the lamp (bulb)and reinstall. NOTE _ Be careful not to drop the screws in between the radiator and the grill, as they are hard to retrieve and usually get stuck on the body panel below the bumper. **you can actually avoid taking out the entire headlight if you just remove anything in the way of reaching behind the assembly. on the right side, it would be the fuse box, on the left side you can probably just reach behind if your hands aren't too large. then remove the rubber seal by prying it off. there is a spring clip that holds in the bulb, remove that by sliding it out from behind the bulb, then remove the bulb and replace.


Turn signals fine with headlight off Headlight on front signals flash slowly rear malfunction Turn R results in rear R lamp off L flashes weakly Turn L results in R lamp flashes weakly L stays on weak?

Check the rear ground wire. Make sure it's properly connected to the vehicle frame.


Where is the Fog lamp switch for 2000 Grand Cherokee Laredo?

The fog lamps are activated on a 2000 Grand Cherokee via the headlight switch. Pull the END of the lever OUT.


How do you replace the headlight on a 1997 Dodge Grand Caravan?

Open up the hood, Locate on top of headlight housing 3 flat head screws, place in a triangle patterned. remove all 3 and then using little flat handle slide out headlight housing. Some cars will have clips holding the socket in. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fixture slide unit back into place, line up screw holes and replace screws tightly. I always like to test the bulb before I put everything back in securely.

Related Questions

How to Replace headlight lamp rav 4?

hit it with a hammer


How do you replace a headlight in a Hyundai XG 350?

Remove cap from back of lamp release pin replace bulb


How expensive is headlight repair?

You can replace a headlight on your own. It doesn’t have to be expensive at all. You will need to purchase a new lamp. The cars manual should explain how exactly to replace the headlight but you can always Google for instructions.


How do you replace whole headlight assy on 2003 jetta?

To replace the headlight assembly on on 03 Jetta, the grill and front bumper have to be removed before you can get to the screws below the lamp.


How do you replace a 2004 Endeavor headlight?

Open the hood, twist/unscrew the grey colored lamp holder and replace the bulb.


How do you replace headlight lamp in Nissan 2005 Maxima?

you take out the broken bulb and put in the good one YES BUT HOW DO YOU REPLACE IT???


How do you remove the head lamp cover assembly on a 2004 Mitsubishi gallant?

the glass cover on the headlight is not servicable, they are glued during assembly. you have to replace the entire headlight globe or headlight assembly.


How do you replace the headlight bulb located on a 1986 Toyota 4Runner?

1986 Toyota 4Runner headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).


What type of replacement headlight bulb do you need for a 2004 Toyota sienna?

2004 Toyota Sienna Headlight Lamp/Bulb Information: It will depend on if you have a halogen system or an HID system. Halogen is the more common. See sources and related links below for standard replacement and upgrade headlight options.


How do you change a headlight on the drivers side?

just unplug the lamp, then replace it, or whatever then replug it to the power. then you should test it.


How to replace headlight lamp on Subaru Outback 2002?

See *Headlight* under Maintenance and Service - Replacing Bulbs, in your "Owner's Manual" (Removing the Headlight Housing Assembly makes life a lot easier).....


How do you remove the driver side headlight lamp on a 2000 Toyota Celica?

If you can't fit your hand between the headlight and the fuse box to unscrew the bulb, take off the bolts at the top and bottom and the entire headlight unit will come out.