First... Read your owners manual - page 226 - Turn the ingnition switch to ON (do not start) and fully depress the accelerator pedal slowly 3 times within 10 seconds and then turn the ignition switch to OFF .
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
No, 1998 to 2000 should be the same, 2001 to 2002, 2003 to 2005, 2006 to 2008, should be the same.
The oil drain plug uses a 13 mm wrench.
its gonna cost u over 1,000 cause i replaced one in my dodge truck its a 01 and it cost 890
Change the pipes for Screamin' Eagle slash cuts. To stop backfiring you will need to fit venturies in the headers and then get the bike Dynoed for optimum performance.
turn the key on, engine off, press the gas pedal to the floor three times. cycle key
To turn off the oil change indicator on a 2008 Dodge Caliber, first, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within ten seconds. The oil change indicator should turn off, confirming that the reset was successful. If it doesn't turn off, repeat the process to ensure it was done correctly.
Turn the ignition switch to ON (do not start) and fully depress the accelerator pedal slowly 3 times within 10 seconds and then turn the ignition switch to OFF .
To reset the oil change indicator light on a 2008 Mercedes S550, turn the ignition on without starting the engine. Press the gas pedal three times within five seconds. After that, the oil change indicator light should turn off, confirming that the reset was successful. Finally, turn off the ignition and start the engine to ensure the light remains off.
owners manual should have that info
Dodge does not use inertia/reset switches.
Exactly the same as the 2008.
Turn on the key....don't start the car. Push the gas pedal to the floor and release 3 times. Should be reset now.
To reset the service indicator on a 2008 Mercedes S320, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds. After that, turn the ignition off and then back on to ensure the service indicator has been reset. If the indicator remains, repeat the process.
To reset the service indicator on a 2008 Polo 9N, turn the ignition key to the "On" position without starting the engine. Press the accelerator pedal three times within 10 seconds. After this, turn the ignition off and then back on to check if the service indicator has been reset. If the indicator remains, repeat the process.
Turn on Ignition - depress gas pedal 3 times
take a hammer to the light