You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.
I believe it's called a trans-axle output shaft seal. Could also be the front differential pinion seal.
try replacing the actuator valve on the front axle
The rear axle hub nut should be torqued to 260Nm or 192 lb/ft - this applies also to the front axle hub nut.
front cause the tranny drive the steer axle
how do u remove cv axle driverside 1991 toyota corolla
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
It would be easiest with an impact, but a breaker bar may work.
it's a TTB
It is 30mm
It does have CV joints but, it is best to just swap out the complete axle assembly than to replace only the CV joint. You will spend much time and almost as much money trying to replace the CV joint than to just purchase a reconditioned axle assembly and swap it.
For Axle Nut its 30mm
It is a 35mm.
54mm
240kgs
159 ft/lbs
159 ft/lbs