0
What else can I help you with?
Why wont your 1997 Saturn SL1 start It turns over but dosent fire Its not the coil or switch?
crank sensor is bad
How do you change the belt on a 1997 Trans Am and is the pulley on the crankshaft where the belt goes?
The pulleys sometimes separate and need replacing. There should be a schematic on the fan shroud.
Will a sunroof motor out of a 97 Saturn. Fit in a 98 Saturn SL2?
It appears so, since The Sunroof Doctor has a replacement motor that will fit 1996- 2002 SL models Sunroof Motor 1997-2002 Saturn SC (2 & 3 Door) 1996-2002 Saturn SL (4 Door) Special! New replacement motor available at this price until our stock is gone. You reuse your original connector or hard wire to your harness $81.55
What is the firing order for a 1997 Saturn sl2?
this can sometimes be a confusing answer, I will try to clearify it as much as i can. According to Saturn timing specifications, the internal fireing order for the Saturn 1.9L motor, both Single overhead cam, or Twin cam is as follows: Left to right 1-3-4-2 If you are routing spark plug wires, and need to know the order of wires from the coils to the engine, the order is as follows: Left to right 4-1-2-3
How do you change the rear u joints on a 1997 Chevy S-10 4X4 blazer?
First mark the drive shaft location at both ends. Remove the bolts holding the U-Joint together and drop the driveshaft. The U-joints are installed and glued at the factory to the rear end and yoke of the drive shaft. Heating the end caps with a torch will force the glue out of the side weep holes where it was injected. Clean well and install new U-Joint and expansion clips provided. Reinsall Drive Shaft to markings.
How do you tighten the bolt on a 1997 Dodge truck transmission output shaft?
You dont.........you buy a new truck...
Replace tube bearing output shaft 97 jimmy?
To replace the tube bearing output shaft on a 1997 Jimmy, first, ensure the vehicle is securely lifted and supported. Drain the transmission fluid and disconnect the driveshaft from the output shaft. Remove any retaining bolts or clips securing the tube bearing and carefully extract the old shaft. Install the new output shaft, reassemble the components in reverse order, and refill the transmission with the appropriate fluid.
1997 Plymouth voyager won't move and makes grinding noises?
Check for a broken cv shaft, if not check trans fluid for debris.
1997 Saturn SL2 is leaking AC freigerent where do you start looking at first?
The seal on the shaft coming out the front of the air conditioner compressor.
Where is the vehicle speed sensor on a 1997 Chevy Tahoe 4x4?
on top of the transfer case output shaft housing. should be held in by a ten mm bolt.
What is the horsepower of a 1997 Trans Am?
A 1997 Pontiac Trans Am has 285hp and 325ft-lb torque.
How do you replace the evaporator core in a 1997 Pontiac Trans Am?
how to take a evaorator out of a 1997 pontiac trans am
How much horsepower does a 1997 trans am have with a v8?
The 1997 Trans Ams have 285 horsepower. The WS6 models had 305.
The how to change CV half-shaft on a 1997 dodge stratus ES?
how to chance a CV shaft on a 1997 dodge stratus
When was Saturn Rukh created?
Saturn Rukh was created in 1997.
What is the shaft in the engine valley for on a 1997 4.3 l Chevy?
That is called a balance shaft.
How do you remove transmission to Pontiac trans sport 1997?
To remove the transmission from a 1997 Pontiac Trans Sport, first, disconnect the battery and drain the transmission fluid. Next, remove the exhaust pipes, drive shaft, and any electrical connectors attached to the transmission. Support the transmission with a jack, unbolt it from the engine, and detach the transmission mounts. Finally, carefully slide the transmission out of the vehicle.
