The gear mechanisms in the steering column may have busted..
also you can try to rotate the steering while,if this doesn't help do it with pair of pliers..got it?!no?!call a locksmith.... Locksmith reply: You can use the pliers to turn it back to the off position but the ignition will need to be replaced. It's pretty common on GM vehicles. Most the time it is just the lock itself that is causing the problem.
The 2001 Chevy Blazer does have an ignition security system that is controlled by the computer in the vehicle. The light might come on because of an error that is coming up in the computer due to a key problem or an ignition problem. This is a common issue with the 2000 and 2001 Blazer.
The 1991 Blazer has a current draw causing the wire to burn. You will need to trace the wiring out to find what is drawing too much current.
A 1996 Chevy Blazer Does have a transfer case IF it is equipped with 4 wheel drive
sounds like the ignition module is failing in the heat.
Ignition control module.. located under the distributor The distributor cap is probably cracked and moisture is getting into it. Replace the cap .
Where is the control module located on the 1983 Chevy blazer
No.
your a fatty
There is 1 per cylinder.
It will not run if you bypass the ignition module (no spark).
First, replace the battery. Then, cycle the ignition between on and off three times. Turn the ignition key into the on position, then the off position, three times. The computer will recognize the key, reboot the computer, and release your key.
The ignition module is located in the distributor, under the distributor cap.
autozone.com
It depends on what year S10 you have.
It does not have 1
In the rear of the distributor.
On the throttle body.