Disconnect Negative (-) battery cable from battery
Crawl under the passenger side of the truck just behind the right front wheel (if you are as thick as me in the middle the truck will need to be raised up, safely please.)
There are two (2) 15mm head bolts holding the starter to the engine block from below.
There are two or more wires attached to the starter, usually 8mm and 15 mm wrenches or sockets needed.
Undo wires
Unbolt and do not drop starter on your head (I have done this, ouch)
The wires may need to be undone with starter hanging loose
Reverse procedure for install.
check starter connection,if 12 volts there probably bad starter
Sometimes. There are two common bolt patterns of Chevy starters, and two common flywheel diameters. Many blocks have both bolt patterns. If the starter bolts up to the block and engages the ring gear without binding, it fits.
Are you sure you pulled the right relay?
i believe it is up to 86 maybe 88 that are the same truck.
If both ends of the positive and negative battery cables are clean and tight, the starter may be telling you it is on its way out.
How to hook the horn up
Hook up what? Need more info.
You can hook up the starter, on your 1984 Chevrolet, by attaching the ground cable and the hot cable to the appropriate posts on the starter. Bolt the starter into place.
A great place is ebay.com or your local salvage yard should be able to hook you up!
On our 1995 Chevy S10 pick up, it's on the passenger side behind motor...looks kind of like a cylinder running lengthwise of the truck. On our 1995 Chevy S10 pick up, it's on the passenger side behind motor...looks kind of like a cylinder running lengthwise of the truck.
get a haynes repair book any aid auto or auto zone has them
I have a 1992 Chevy S10 pick up and the fuel pump on my truck is inside the gas tank.
How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck
firing order pick up s10 2001
You should hook up the wires for a tach on a 1985 Chevrolet s10 blazer to the negative side of the coil. You should be sure to identify the positive and negative sides of the coil.Ê
06.0 on a 4cylinder 2wd s10
There should be two on the large terminal and one on the small terminal I believe the small terminal is labeled S