Saturn key stuck in ignition

Answer 1

Ask your mechanic, he would know better. But, there is a pin near your gear selector that is engaged when you are in any drive gear, park or neutral, as well as when your key is in the running position, start position etc, that is not functioning properly. The pin is in a state of "feeling" like you are still in any one of those positions and you obviously know that you can't pull your key out of the ignition while your car is running anyway. So this pin has your key locked in the ignition because it thinks your car is still running.

Answer 2

If the key is stuck in the ignition you will need to get it looked at by the dealer. One temporary solution is to pop off the cap next to the shifter console and you should be able to remove the key by sticking a pen in there.

Answer 3

The ignition on the Saturn is very tight and usually causes thinning of the key. The buildup of brass gets into the mechanisms within the ignition cylinder. First lubricate the lock if possible. Then attempt to move to the accessory position and turn off. If this can't be done, then call a locksmith to remove the key- they are way cheaper than a dealer and you would probably save the ignition.

The common procedure for a locksmith is to get the key to at least the accessory position. If the lock will not push in and turn through manipulation of the key, then the key will usually be drilled out. Again, a locksmith is the best for this because of their knowledge and ability not to destroy the lock. with drilling the actual key (which would be broken off even with the ignition) the vibration and rocking will usually cause the release mechanism to eject and the ignition to turn back off. The key can then be removed and a new one cut. When the key is out, lube the heck out of the cylinder to wash out all the accumulated brass.

Answer 4

Key is stuck in ingnition

Answer 5

pray!