Some (front wheel drive) cars have a flexible piece of pipe that connects the exhaust manifold to rest of the exhaust system. The length of pipe is designed to allow the engine to rock back and forth on its mounts. Without the flex joint, the movement of the engine would damage the rest of the exhaust system.
Quadriceps contracts to extend the knee joint. Rectus femoris, the part of quadriceps flex the hip joint on the thigh.
it is on the driver side just beneath the exhaust manifold. you will need to remove the exhaust or the cv joint to drop the starter
No, it will just make the car loud.
If the vehicle has a stainless steel exhaust system it will last the life of the car. If it does not and you drive in roads treated with salt it will not last as long. Surface rust does not mean the exhaust in need of repair. Surface rust is normal on a steel exhaust system.
squeeking from exhaust manifold is caused by a leak allowing exhaust gas to leak. it will only get worse as time goes on unless it is fixed
A car that has a bad exhaust flex pipe will not pass inspection in any state that requires it. The pipe will need to be fixed before the car is inspected or it will fail.
That would be a flex joint.
You can use regular exhaust pipe providing it fits and you can bend it into the location.
usually an exhaust leak under the hood(exhaust manifold or o ring/flex pipe that fastens to solid pipe).your car pulls air from the front windshield area,and it seeps into it and blows in
An exhaust flex pipe is made of layers of woven stainless steel.
No, a Strut is basically a shock with a built on spring.A CV joint is the "flex" joint in a drive shaft.No, a Strut is basically a shock with a built on spring.A CV joint is the "flex" joint in a drive shaft.
The knee helps your leg flex and extend.
fixed joint
The purpose of the flex pipe is to give the exhaust some flexibility. On front wheel cars since the motor is mounted crosswise, when you give it gas the motor rocks and would over time break the exhaust pipe or even the exhaust manifold. On rear wheel drive cars, the exhaust pipe can twist which gives the needed flex. As far as components, it is just a woven metal sleeve over a piece of pipe that isn't attached to the ends of the flex tube. The outside woven part allows the exhaust to flex.
One set to flex a joint, the other to extend a joint.
Need more info. It can be many things depending on the vehicle... u-joint motor mount bushing cv joint exhaust hanger internal transmission problem
An exhaust flex pipe is a braided stainless steel pipe that allows for some movement between exhaust pipes (usually around 6-8" long). It is made of interwoven wires of stainless steel. A flex pipe will need to be replaced within the life of a vehicle and a tell tale sign of expiration is when wires are sticking out or loud exhaust can be heard from that area.