0
What else can I help you with?
I just replaced the starter in my 81 gmc short box with a 350 cc engine and when i attempted to connect the battery cables it would start cranking over trying to start why would this happen?
There are two SMALL wires on the starter. They are connected wrong.
Diagram on how to replace the starter on a 1979 Chevrolet Impala?
Assuming a 350 engine, the starter is located on the passenger side of the engine, below the exhaust manifold. It is held in place with two bolts at the front, and one bolt securing a rear bracket. Disconnect both battery cables at the battery before beginning the job. The positive battery cable plus two more wires attach to the starter solenoid which is removed with the starter as one unit.
Where is the starter on a 1993 Blazer 350 engine?
The starter location on all Dodge Dakota engines is on the driver's side rear of the engine, low down and bolted to the transmission bellhousing. It will be cylindrical in shape and the positive (red/+) battery cable will run directly to it.
Is an alternator on a 350 engine the same on a 305 Chevy engine?
yes
What is wrong if the starter kicks out after turning over the motor about two revolutions?
SAME PROBLEM. Reco Holden 186 engine with a clutch. Engine recently fitted with Yella Terra head and 350 Holley. Compression probably high but starter spins the engine ok. I have a starter moter that drops out, as though the engine has fired. Ive disabled the engine from starting and still the starter drops out after perhaps one revolution of the engine. Ive had the starter out and is working fine. The teeth on the cog show no signs of wear nor are the teeth burred in any way. Anyone would call it a good starter. Took it to a auto elec for a second opionion. Its fine. We agreed it was a good idea to shave off three milimeters from the end of the starter to alow the cog to enter into the ring gear ferther. This done and refitted it still drops out before the engine has a chance to fire. Cover plate removed from clutch and inspected ring gear. A few fine burrs or rather a sharp edge on the ring gear was found. Dident think it would affect the starter but filed off the sharp edge and carefully inspected (and checked with a file) each tooth TWICE! Starter still throws out before the engine fires. Still drops out after about one revolution of the engine.
How do you hookup a starter 350 Chevy?
There's two wires to connect... just put them where they belong. Positive to the solenoid, negative to the starter body.
I just replaced the starter in my 81 gmc short box with a 350 cc engine and when i attempted to connect the battery cables it would start cranking over trying to start why would this happen?
There are two SMALL wires on the starter. They are connected wrong.
You have put a 350 high performance engine in a 1981 el camino and it originally had a v6 in it with 2 wires going to the starter the 350 engine starter has 3 wires how can you make this work?
You should only need to wires to starter. The big wire from your positive battery post goes on the big stud on the starter, you may also have some wires with that same size hole that go there too. You should then only need to put the purple wire on the post that's closest to the engine. Hope the info helps.
How many wires are on a 1996 Tahoe with vortec 350 starter?
8
How do you replace a starter on a 1978 nova?
On the passenger side of the engine, whether is a 250, 305 or 350, disconnect your battery & go under the car on the passenger side. Disconnect the 2 wires on the starter solenoid & then take out the two bolts holding your starter to your engine. Installation is the reversal of this.
Where do wires go on 350 chevy mini starter?
The starter needs a large wire from the battery and a wire from the starter switch. These are connected to the solenoid that is attached to the starter.
How many bolts connect a 350 turbo transmission to a 350 engine?
6
How do you change a starter on a Chevy 350?
Disconnect the - battery cable Raise and support vehicle Remove wires at top of starter Remove starter mounting bolts Remove starter
How do you remove a starter from a 1993 Buick Roadmaster with a 350 engine?
To remove the starter from a 1993 Buick Roadmaster with a 350 engine, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is positioned on the passenger side of the engine. Remove the electrical connections and the mounting bolts securing the starter to the engine block. Finally, carefully slide the starter out from its position.
Where is the starter on a 1999 F-350 Power Stroke?
starter motor is on the passenger side at rear of engine where the engine and bellhousing join
Is there a freeze plug behind the starter on a GMC 350 engine?
YES there is. You will need to remove the starter to see it.
Install starter on 1994 caprice?
What engine? 350 LT1.. it's under the passenger side of the engine against fly wheel cover. Two bolts (plus wires). All (99%) of Chevy engines have their starters in the same place.
