The 2.5 litre V6 engine in a 1995 Ford Contour doesn't have a timing belt ,
it uses ( 2 ) timing CHAINS
You can, but I would not recommended. Due to it's not a new truck and high mileage. You can put 10W30 or 10W40 instead. I think the 5W30 may hurt your engine.
Check for fuel and spark.
Check engine light will appear, engine may run poorly and fuel mileage will drop.
your engine will never warm up properly. it will decrease gas mileage. engine will not run right. just get the right thermo, and replace it.
Change password for the start engine for citroen saxo?
It depends on the engine type. On a 2.0 Petrol the recommended mileage to change the belt is 72,000mls, but you can always change it before.
The chain will last the life of the engine and there is no recommended change interval.
what engine??
No, the mileage is stored in the body and engine computers.No, the mileage is stored in the body and engine computers.
According to the 1998 Ford Contour Owner Guide ( 5W-30 ) With engine oil filter change : The 2.0 litre four cylinder takes ( 4.5 U.S. quarts of 5W-30 ) The 2.5 V6 ( 5.8 quarts )
When a vehicles engine is maintained as recommended you will have a longer engine life. There will also be less repairs over time, and the fuel mileage will be higher.
Your 3.3 liter V6 engine has a timing BELT =- - the factory recommended change mileage is 90,000 miles.
MAKE CERTAIN that that is all that it is and not signalling the failure of some vehicle system! If it is TRULY the 'check engine' light it is probably signalling that you've gone past the recommended mileage for an oil change.
RECOMMENDED BETWEEN 60, 000 kms and 80, 000kms * Replace engine timing belt (Except vehicles with timing chain)
The 1998 Ford Contour owners manual shows for the 2.0 L engine : WITH FILTER CHANGE - 4.25 liters ( 4.5 quarts )
Change engine oil and filter every 3,000 miles or 3 months, whichever comes first.
High Mileage, Zinc-enriched 50 weight from Valvoline.