sounds like selector in transmission is broken if you can move the shifter but the trans does not change you may have broken the shift cable.
shifter
You undougetly did somethig wrong. Try adjusting the switch first.
under the knob, there should be a locking nut on the shift rod. Loosen this and the knob should just unscrew
Saginaw 4 speed. It is an exact bolt in. Only change is you need a 4 speed shifter.
If the shift knob on a 1995 Chevy Beretta broke off from the metal bar, the metal bar is called the shift lever. The shift lever might be available at a reduced price from an automobile salvage yard.
the normal is regular and a reverse is better
how do i remove Chevy aveo 2006 shifter knob
Possible shifter or linkage problem? ie: not actually going into reverse. Ummmm, you didn't zoom the tires in reverse and blow the gear did you... Hope that helps.
shifter
no
Both. The Monte Carlo SS had a floor shifter (what I own), but the regular monte's had column shift
the shifter is all in one. you have to replace the whole shifter. the nob is attached
Professionally, it will cost around $2,000 to replace a broken shifter and clutch in a 96' Chevy Beretta. Just the replacement clutch and shifter will end up costing you around $800.00.
The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.
== ==
You connect your floor shifter to your transfer case in a 4x4 Chevy truck 1993 by getting under the truck and looking for the rod that comes from the shifter to the transfer case. Then, use the pin connector to connect the rod.
It sounds like the transmission shifter linkage is disconnected.