no fuel means check fuel pump for operation.also make sure fuel filter is not full of gunk
I did have the same problem but found that after inserting the key into ignition I deed to wait +/- 3 seconds and I can hear the start relay (on the relay pannel) click in. If I do not hear this relay click in the car just does not start (No spark from the electronic coil to the distributor).
It is about 18 inches up from the floor on the pass side of the cab. Find it and you will see how to reset it.
look in the trunk. if it has the relay button, it would prolly be on one of the sides, usually in a compartment. it would be a red button if im right. hope i helped
Reset the fuel shut off switch.
You cannot bypass or reset the Securilock anti-theft system on a 99 Ford Ranger. If the system begins to malfunction and you can no longer start the vehicle, you will likely need to replace the transponder unit that is located behind the ignition in the steering column.
I have checked the fuse and relay. How do I reset the A/C on my 2000 Intrepid
The 1998 Ford Ranger owners manual shows a starter relay in the power distribution box in the engine compartment . It is the # 6 relay . Ford suggests disconnecting your battery before servicing anything in the PD BOX , which means your Ranger will have to relearn its idle , the radio clock and stations will have to be reset etc.
The battery warning light illuminates when the battery isn't being charged , get it checked out to find the problem and then repair.
It is just right of the transmission hub under the dash and pull the carpet down to see it.
Relay, yes. Reset switch, no.Relay, yes. Reset switch, no.
2005 ranger code 32 reset
The ASD is a relay controlled by the PCM and does not have a reset.The ASD is a relay controlled by the PCM and does not have a reset.
I have a 2004 ford f150 heritage supercab i changed the fuel pump because it did't have any power and still no power all fuse are good and relay
There is no reset function on a fuel pump relay. It is controlled by the engine computer.Dodge does not use inertia/reset switches.There is no reset function on a fuel pump relay. It is controlled by the engine computer.Dodge does not use inertia/reset switches.
a starter has been changed on the car and its turning over but want crank i checked and reset the fuel button and still want crank but will turn over.
You do not have to reset the asd relay. It is controlled by the engine computer automatically.
Push the reset button.