answersLogoWhite

0

What else can I help you with?

Related Questions

Why would the engine of my 1995 econoline ford van sometime not start yet turns over?

check your ignition module, especially if it a straight six.


Trouble shooting engine turns over but does not start on 1995 ford econoline?

Check the starter and selenoid-check to make sure all electrical connections are snugged-test alternator


96 Chevy s10 turns over but will not start Any ideas why?

Start looking at fire and gas. Trace these two that are the main problems.


1991 cressida turns over but will not start afterwards it floods there is no power from dcap but coil is ok any ideas?

Check the Ignitor


My 73 MGB turns over fine but won't fire until you let off the key any suggestions or ideas what that could be?

You might want to check the starter-it has start contacts,that increases the voltage for start


97 Altima won't start it has spark and fuel It turns over but does not catch any ideas?

The distributor might need to be changed. The spark plug cables are connected to it.


Distributor cap firing order 1993 ford econoline 4.9L?

1 - 5 - 3 - 6 - 2 - 4 The distributor rotor turns CLOCKWISE


When turning the key it turns but won't start the vehicle not the battery starter fuel filter alternator etc any ideas about the ignition?

Spark to cylinder (at random)? If yes... How is the timing?


2001 celica gt wont start turns over fine. but will not start where should i look first.any ideas?

You need to narrow down the possiblities, check for spark, check for fuel, then check compression. One of those is missing.


Where does Bill Kaulitz get his ideas to write songs?

he gets his ideas from his personal life he writes down how he feels and it turns out to be a song


How would you know if someone turns against you?

If someone turns against you,they start behaving bad. They start ignoring you and not caring for you.


Why does maytag neptune dryer lights up turns on you push start and it clicks once and doesnt work you opened the top and heard the click louder coming from around the circuitboard Any ideas?

The timer is probably bad, if it won't advance the cycle will not start.