The emergency signal flasher module can be found below the dashboard, on the drivers side of the engine compartment. The emergency signal flasher module simply plugs in and out.
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
The turn signals and emergency flashers are both controlled electronically. The module is behind the emergency flasher switch and requires partial disassemble of the dash to access it There are several screws: 2 on the ends under the fuse covers 2 on the panel under the steering wheel and 2 by the odometer Gently pull the face off the dash. Don't break off the clips. A replacement is about $40 from the dealer.
check the flasher,your 4 way flasher is different then your turn signal flasher,they both should be under the dash on the left side,they both look same,check your manual,it's about a $2-3 item
If hazard warning switch is in dash board--turn signal flasher may be part of that module--try "jiggling" the hazard warning switch If hazard warning is in steering column look under dash for turn signal flasher --driver's side steering column
The turn signal/hazard flasher are controlled by the ETACS module, an integral component of the interior fuse and relay box under the driver's side dashboard. If you're sure it's the flasher, you'd probably have to replace the whole box. Check your hazards (four-ways) If they don't work either, change the switch.
It should be located on the dash just up and left of the sterio near the instrument cluster
In the fuse box the round silver flasher.
The turn signal flasher on a 2001 Chevy Cavalier is located inside a panel close to the gas pedal. The turn signal flasher is very easy to change and they can be purchased from many auto parts shops.
Flasher unit. there's a hazard flasher on your dashboard on top of your stereo where you turn on your emergency lights on.that flasher comes out with a thin screwdriver just pull it out and unplug it then plug it back in that would solve your problem if not that's that flasher you need to replace new
you need to change the flasher can for the signal lights
To change the turn signal flasher on a 1993 Toyota Corolla, locate the flasher unit under the dash on the driver's side. Pull out the old flasher plug and replace with a new one. This part has a three-prong plug that can be removed without hooking up or unhooking wires.
The turn signal module is combined with the hazard light module. You need to remove the dash trim to get to it. It is right behind the hazard light switch.