I have a 51 plate Peugeot Partner van with a standard radio. The radio code should be a 4 digit code with each number having the value of 6 or less. The code is entered using just the 1-6 radio channel numbers, and that's it no need to press any other buttons the radio should just spring into life!
Good luck
Tommo
Radio code Peugeot bipper
To unlock a Peugeot car radio displaying a "4 Error" message, you'll typically need to enter the correct unlock code. This code is usually found in the vehicle’s user manual or can be obtained from a Peugeot dealership by providing your vehicle’s VIN and proof of ownership. If you have entered the wrong code multiple times, the radio may become locked for a period, so patience is necessary. After obtaining the correct code, follow the radio's prompts to input it and regain access.
You input the code with the radio preset buttons.
The radio comes with a code. Turn on the radio and input the code. Once you have finished putting in the code, the radio will begin to play.
the radio has message error 6
By using the radio preset buttons.
In order to input the radio code into a MErcedes E320, the user must have the means to input into the main control box, located in the center of the dashboard. From here, one can locate the input panel.
If you've recently interrupted the power supply (battery) then you will need to input the radio code. The code should be in your paperwork, if not, contact your dealer for the code. The "WAIT" code on the radio means you have input the wrong code more than 3 times and you have to wait 10 minutes before attempting to enter radio code.
I had this problem several times and its a fail safe. If the battery or radio is disconnected the radio will need a code. Once the right code has been put in it should never ask you again unless you disconnect the battery again. You should be able to get the code from Peugeot.
just disconnect the negatif terminal on the battery for 5 min...and then reconnect,and switch on the ignition wait till 10 sec an then start your engine..
hold the as button down and than enter your code
To unlock a radio you must input the radio code. This is done using the preset radio station buttons on the face of the radio. Contact your dealer for more info on your radio code if you don't have it.