answersLogoWhite

0

Disconect neg on battery, remove outer primary, remove jackshaft( keep parts in order when removing) remove rear tire, a motorcycle lift works good, disconect positive to starter, remove 2 1/4 inch allen bolts from starter, pull starter and catch spacer(notice direction of spacer it only goes back the way it came out.) Go to rear of swing arm pull starter from rear by the rubber fender guard. Replace in order the way it came out. It can be a pain but it's the only way I could replace mine.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you change starter solenoid on a Harley Davidson?

Remove the starter. the solenoid is mounted on the starter.


How do you remove starter bendix 0n 1985 harley Davidson fxr?

how do i replace the bendix drive in my 85 harley fxrs


How do you remove starter Harley Davidson Fatboy 1998?

you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.


What size wrench do you need to remove the transmission plug on a 2006 Harley Davidson Electra Glide?

A 5/8" socket wrench.


Oil plug location electra glide?

The Harley-Davidson Electra Glide motorcycle oil plug is located on the bottom of the oil pan. You can remove the oil plug with a half inch ratchet.


How do you replace a stator on a 1995 Harley road king What does the stator do?

Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.


How do you remove the starter haarley Davidson softail 1987?

To remove the starter from a 1987 Harley Davidson Softail, first disconnect the negative battery cable to ensure safety. Then, remove any components obstructing access to the starter, like the exhaust or primary cover, if necessary. Next, disconnect the wires from the starter, noting their positions, and remove the mounting bolts securing the starter to the engine. Finally, carefully pull the starter out of its housing.


How do you remove a 1987 Harley Davidson starter motor?

To remove a 1987 Harley Davidson starter motor, first disconnect the battery to prevent any electrical shorts. Then, locate the starter motor, usually mounted near the engine, and remove the bolts securing it to the engine. Disconnect the wiring harness and carefully pull the starter motor out of its mounting location. Finally, ensure all connections are clear and check for any debris before installation of a new starter, if necessary.


How do you remove starter on 1993 Harley Davidson FXR?

You buy a service manual and study it very carefully. It's worth it, cost is about $30.


How do you remove an ignition switch from a 97 harley Davidson ultra classic electra glide?

To remove the ignition switch from a 1997 Harley Davidson Ultra Classic Electra Glide, first disconnect the battery to ensure safety. Next, remove the headlight assembly by unscrewing the retaining screws and gently pulling it away from the housing. Locate the ignition switch, disconnect the wiring harness, and remove the retaining screws or bolts securing the switch in place. Finally, pull the ignition switch out of its mounting position.


How do i repair a starter on a 1988 Harley Davidson flhtc?

simply put, buy a repair manual; you are going to need it. Be prepared to remove the primary cover.


How do you remove the starter on 1987 Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.