If it is the Comfort Flex Seat, raise seat to it's highest level, place 2x4 under front nose of seat to protect seat from slipping and crushing your hand. Unbolt the two bolts that hold a clamp of metal around cross tube above battery and oil tank. Remove plate from under tube by sliding it's tabs out of slots. Now unbolt rear seat bolts from rear fender. Take care lifting seat assembly to avoid scratching rear fender, frame and fuel tanks from the floppy under seat assembly.
To remove the seat on a Harley Davidson Road King, you must unscrew the Philips head screw that is directly behind the seat. Then, slide the seat and unfasten the hook at the front of it.
Remove the seat. Remove the battery. Replace the battery. Replace the seat.
To remove the battery from a 1999 Road King Classic FLHRC-1, first ensure the motorcycle is turned off and secure. Locate the battery under the seat; remove the seat by loosening the screws or bolts holding it in place. Once the seat is off, disconnect the negative (-) terminal first to prevent any short circuits, followed by the positive (+) terminal. Finally, remove any securing bracket or strap and lift the battery out of the compartment.
Remove the screw behind the seat that goes into the top of the rear fender. Lift the rear of the seat and pull straight back, away from the fuel tank. If there is a passenger grab strap, you can pull the seat through the strap or remove the strap.
No it wont fit (from experience) the frame shape is different as is the front seat mount
On a 2005 Harley-Davidson Road King, the fuse panel is typically located under the seat. To access it, you need to remove the seat by loosening the mounting bolts. Once the seat is off, you'll find the fuse panel mounted on the right side of the bike, near the battery.
You turn the bolts to the left.
remove bolt on the back of passenger seat, pull that back and out. Then driver seat just pulls back and out as well.
To remove the seat from a 2004 Harley-Davidson Road King, first, locate the seat mounting bolts or screws, typically found at the rear of the seat. Use a socket wrench or screwdriver to remove these fasteners. Once they are removed, gently lift the rear of the seat and slide it backward to detach it from the front mounting points. Finally, lift the seat away from the motorcycle.
To remove the seat from your 2005 Harley-Davidson Road King, first ensure the bike is on a stable surface and the ignition is off. Locate the two screws or bolts securing the seat at the rear; these are typically found under the seat's rear edge. Use the appropriate tool, usually a Torx or Allen wrench, to loosen and remove these fasteners. Once the screws are removed, lift the rear of the seat up and slide it back to detach it from the front mounting points.
Under the seat.
The fuse panel on a 2005 Harley-Davidson Road King is typically located under the seat. To access it, you need to remove the seat, which usually involves unscrewing a couple of bolts. Once the seat is removed, you will find the fuse panel mounted on the bike's frame, usually near the battery. Always refer to the owner's manual for specific details and safety precautions.