To remove the water outlet housing from a 2002 Dodge Intrepid, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant and then remove any components obstructing access, such as the air intake or hoses. Unbolt the water outlet housing from the engine block, typically held by two or three bolts, and gently pry it off. Finally, clean the mating surfaces and replace the gasket before reinstalling the new or cleaned housing.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
Unlike other cars, the Intrepid requires you to remove the entire headlight housing. This is very simple, there are to long bolts on top of the housing that hold the housing on. Simply remove these bolts, untwist the bulb, replace the bulb.
Follow the top radiator hose to the engine. It goes to the thermostat housing. Remove the 2 bolts in the housing and the thermostat is right below it.
how do you remove the flasher relay in a 2000 dodge intrepid. I got it unplugged but don't know how to remove it
The thermostat on a 2.7L Dodge Intrepid is under the housing where the lower radiator hose attaches to the engine.
no no
It is not where the housing is. You have to lift car and its behind alternater.. not easy but possible
On the passenger side bell housing on the near the transmission.
Under the housing where the lower radiator hose hooks to the engine.
The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
top of the engine, under the housing the upper radiator hose hooks to.
It is under the housing where the lower radiator hose hooks to the engine.