To remove the exterior trim for the rear window of the Corolla simply pull up. The hinge system should allow for easy removal. The question is where do you find the trim to replace it with...
Hope this helps!
How to remove Window Winder Handles from VZ Holden Commodore
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
there is a clip behind handly use a rag and run it around the hand and door panel and it will come off
To remove the window winder on a VW Lupo, first, ensure the window is fully closed. Use a flathead screwdriver to carefully pry off the plastic cover at the base of the winder handle. Once the cover is removed, you'll find a retaining clip or screw that secures the winder; remove it using the appropriate tool. Finally, gently pull the winder off the shaft to complete the removal.
remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
Just pull it!
To remove the window winder from a 1996 Hyundai Excel, first, use a flathead screwdriver to carefully pry off the decorative cover, if present. Next, locate the retaining clip or screw that holds the winder in place; remove it using the appropriate tool. Afterward, gently pull the winder off the window crank shaft. Be cautious not to damage the interior panel during this process.
take it to safelite lol
With a knife. A sharp one.
To remove the window winder on a VX Commodore, first, use a flathead screwdriver to gently pry off the decorative cover from the winder handle. Once the cover is removed, you’ll see a small retaining clip or screw that holds the handle in place; you can either unscrew it or carefully remove the clip with the screwdriver. After that, simply pull the window winder off the shaft. If it’s stuck, you might need to wiggle it back and forth while pulling.
To remove the window winder on a Daewoo Matiz, first, use a flathead screwdriver to carefully pry off the decorative cap from the winder handle. Once the cap is removed, you will see a retaining screw; unscrew it using the appropriate screwdriver. After the screw is removed, pull the winder handle off the spindle. If it’s stuck, gently wiggle it while pulling to free it.