This might help: http://www.carstereohelp.com/stereoremovalHyundaiExcel.htm
On the 1989 Hyundai Excel, the fuel pump is located inside the fuel tank. To access it, you'll typically need to remove the rear seat and then take off the access cover, or alternatively, you can remove the fuel tank itself. Always ensure to follow safety precautions when working with fuel systems.
Take it to a mechanic
Take to the Mechanic .... LOL
you have to take out the stereo and it is usually on the barcode on it. It is a 10 digit code and usually starts with the letters HS, HA, HC.......
if you are asking this question on a website,,,,get someone else to do it,,,,I can explain how to do it,,,,,but you will not understand unless you have someone there to guide you,,,,take it to a professional
To replace the CV joints on a Hyundai Excel, you'll need to lift the vehicle and remove the wheel. Then, take off the brake components and disconnect the axle from the hub. After that, remove the retaining clips and pull the CV joint off the axle. Finally, install the new CV joint, reassemble the components, and ensure everything is tightened properly.
If it is doing that, it means you have a blown transmission. You need to take it to the repair man immediatly
what kind of freon does Hyundai elantra take?
if it is anything like my 2006 Hyundai accent then you have take take off the black trim around the stero.. there are about 6 places where you need to pry. the corners and the middle areas. kind of tough to get off but just keep pulling. you wont break anything. just pull hard. after that is off all you have to do is unscrew the srews
normally it runs with 87 octane gas... i always use 91-93 octane is more expensive but keeps the fuel system cleaner and healthier
To remove the ignition barrel from a Hyundai Excel, first disconnect the car battery to ensure safety. Next, remove the steering column covers to access the ignition assembly. Insert the key and turn it to the "On" position while pressing the release pin or tab on the ignition barrel. Finally, pull the barrel out gently, making sure to disconnect any wiring harnesses attached to it.
On top of the middle console on the right. This button needs to be removed to take out the middle console, so it happens the plastic click systems fails and the button wont go back on.