answersLogoWhite

0

there isn't 1

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you bleed a diesel pump for vauxhall astra?

To bleed a diesel pump on a Vauxhall Astra, first ensure the fuel tank has sufficient diesel. Locate the bleed screw on the fuel pump, usually near the fuel filter. Using a wrench, loosen the bleed screw slightly and turn the ignition key to the "on" position without starting the engine, allowing the fuel to flow and air to escape. Once you see a steady stream of fuel without bubbles, tighten the bleed screw and attempt to start the engine.


Where is the radiator bleed screw on a 94 BMW 525i?

next to the radiator cap on top of the radiator


Where is the radiator bleed screw on a 99 ford ranger?

At the bottom of the radiator, you can see it from under the truck.


Where is the bleed screw on a citroen c3 coolant system?

It is on the pipe behind the engine that goes to cabin radiator


What does the bleeder screw for antifreeze on 1990 Subaru engine look like?

Not all subaru engines have the bleed screw.Models equipped with the screw is loacted at the top of radiator


How do you bleed the cooling system of a Dodge Intrepid after flushing the radiator if this vehicle has a bleed screw?

the library should have a shop manual for this vehicle, you can make copies of the right sections :)


How do youFix air lock in heating system peugeot 405?

You have a bleed screew in the top hose from the radiator undo it slightly to let the air out.Once bleed retighten the screw.


How do you get the air out of the coolent system on a?

open the plug (screw) at the bottom of the radiator, open the radiator cap and let the system slowly gravity bleed while pouring more fluid into the radiator. do this with vehicle off.


Where is the coolant bleed screw on a 2000 Chrysler 300M?

It is hidden on the intake near where the upper radiator hose attaches.


How do you bleed the cooling system in a 306 gti-6?

To bleed the cooling system in a Peugeot 306 GTI-6, start by ensuring the engine is cold. Remove the radiator cap and the bleed screw, usually located on the thermostat housing or near the coolant hoses, to allow air to escape. Fill the radiator with coolant until it overflows from the bleed screw, then tighten the screw. Finally, run the engine until it reaches operating temperature, checking for any air bubbles and topping off the coolant as necessary.


How do you bleed the fuel system on a Vauxhall Omega 2.2Dti?

To bleed the fuel system on a Vauxhall Omega 2.2 DTI, first ensure the fuel tank is adequately filled with diesel. Then, locate the fuel filter, and loosen the bleed screw on top of the filter. Crank the engine for a few seconds to allow fuel to flow through and remove any air, then tighten the bleed screw once fuel flows consistently without bubbles. Finally, start the engine and let it run to ensure it's operating smoothly.


Where is the coolant bleed bolt-screw location on a 1990 acura integra GS with the 1.8litre dohc?

where the upper radiator hose connects to the engine you should see a little bleed bolt