answersLogoWhite

0

To bleed the cooling system in a Peugeot 306 GTI-6, start by ensuring the engine is cold. Remove the radiator cap and the bleed screw, usually located on the thermostat housing or near the coolant hoses, to allow air to escape. Fill the radiator with coolant until it overflows from the bleed screw, then tighten the screw. Finally, run the engine until it reaches operating temperature, checking for any air bubbles and topping off the coolant as necessary.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

Will a 306 gti6 fit in to a 306 convertible?

Yes it will. nice and simple answer.


Will a 306 gti6 gearbox fit a 2001 306 1600 manual lump?

No!


Will a 306 gti6 engine fit in to a 306 convertible?

Yes it will. nice and simple answer.


How do you bleed petrol fuel system peugeot 306?

Shoot it. I find shooting people makes them bleed... same basic idea.


Where can I buy parts for the 306 gti6?

If one requires parts for the Peugeot 306 GtiI6 they are not widely available in North America. One can find parts available on the eBay site or on UK sites such as Gumtree.


Will Peugeot 306 gti6 brakes fit a Peugeot 106 gti?

yes, but the carrier will need grinding on one of the corners. may also be better off with new lines as well.


How do you restart peugeot 306 after running out of diesel?

you will have to open a injector on the engine to let the fuel bleed make sure all air is out the system


Why does the cooling system kick in after a few miles on my peugeot 306?

If by cooling system you mean the cooling fan, it takes a while for the coolant temperature to rise enough to trigger the temperature sensor that activates the fan. This is to help warm up the engine and to avoid unnecessary operation of the cooling fan when it is not needed.


How do you bleed the brakes on 306?

if you want a clean bleed you will need a cup and a pencil and duct tape.Pierce the tyre with the pencil and let it bleed into the cup and seal it with the duct tape and you are free to go


Where is the thermostat on pug 306 s16?

The thermostat for the cooling system can be found on the front of the engine. You can follow the bottom radiator hose to the thermostat housing. The thermostat will be within the thermostat housing.


What is 306 as a decimal?

306 as a decimal is simply 306.0. In decimal form, whole numbers are represented by themselves followed by a decimal point and a zero. This is because the decimal system is based on powers of 10, where each place value represents a power of 10.


Peug 306 TD temp needle almost in red but plenty water and no hissing when expansion bottle opened Air lock?

Sounds probable - there are a couple of bleed points around the system. Start the engine when cold and keep bleeding until you get nothing but water.

Trending Questions
Will a 1997cc dohc turbo 16 valve engine fit into a 97 Mitsubishi eclipse rs? How do you change tail lights in 2011 Dodge Durango? Where can you find a diagram for rear brakes for a 1992 Chevy 1500 pickup? How do you change the timing belt on a 1990 Ford Ranger manual transmission 2.3 Liter 4-cylinder vehicle? How do you put a vl commodore airflow meter to a 1988 magna? Does a 2000 Dodge Stratus have a MAF Sensor? What fuse should be used to replace the burned one? How do you change a fuel filter on a 2003 Land Rover discovery? Where is the fuel filter located on a Daewoo Leganza? How do you loosen the power steering pump to replace the belt? How do you know if the fuel pump on 1998 chev 2500 silverado 340 5.7 is bad? Where is the exhaust gas recirculation valve EGR located on a 97 s10 Chevy blazer 43L AC v6? How many quarts of transmission fluid to add after servicing transmission for 2005 mercury moutaineer? How to hook up zune to home stereo? 97 Buick sometimes it smells like rubber or something burning when the heater is running antifreeze is low at times is this a intake problem? How many quarts of oil go in my 383 stroker crate engine? Code po335 was set car would not start replaced ckp sensor car ran good for 7 miles then bucked and died set code again po335 2002 Nissan altama witha 2.5 auto? Why after getting a oil change does your car overheat? How do you turn off the Maintenance Required light on your 2005 Toyota Corolla? What is product selling on an OEM basis?