0
Get two #168 bulbs,open the hatch look on the passenger side behind the plate for the inset handle remove the screw ,pry off the plastic cover.the bulb holders are up in two cutouts behind the license plate squeez the conector and turn the bulb holder will come out .replace the bulb then replace the holder then replug the wire.ps dont drop the connector its a pain to get it out
What else can I help you with?
How do you change license plate lights in a 1997 Toyota Celica?
There are plastic bulb covers on either side of the license plate. Unscrew the screws and take the covers off. From there you can insert new bulbs.
How do you wire license plate lights on a gas scooter?
to wire the license plate lights you must have lights and wire them to the scooter.
Are the license plate lights in the warning circuit for the brake lights of your 1986 Honda Prelude?
No, the license plate light is wired in with the rear tail lights, not the brake lights.
Do 2002 Ford Focus have 2 lights on license plate?
yes 2002 Ford Focus do have 2 lights on license plate
What number of fuse controls the license plate lights on a 2003 Expedition?
The license plate lights are not in a separate fuce by it seft. They are the same as your side marker lights. So, check if your side marker lights are working and if they are them is a bad license plate light bulb.
How do you change the lights over the license plate of a 1991 Chevy Camaro?
You can remove the panel inside the back of the car. From there you can access your tail lights and your tag lights.
Where are the tag lights?
That would be the lights that illuminate the rear license plate.
Do motorcycles need license plate lights?
yes.
Where is fuse for license plate lights?
Radio fuse
How do you change the tag lights on 92 deville?
The following Instructions are for all 1991, 92, 93 DeVille Sedans and Coupes.Remove rear license plate.Remove 4 nuts underneath license plate.Separate license pocket (with reverse lights) from body.Remove license plate lamp socket from license plate pocket (1/4 turn counter clockwise)Pull bulb (straight out) from socket.Push new bulb into socket (line up blade to slot in socket).Install license plate lamp socket to license plate pocket (1/4 turn clockwise)Install license pocket (with reverse lights) on to body.Install 4 nuts underneath license plate.Install rear license plate.
Where is the fuse for license plate lights for 2000 Lincoln ls?
In the 2000 Lincoln LS, the fuse for the license plate lights is located in the fuse box, which is typically found in the engine compartment. You can refer to the fuse box cover or the owner's manual for the exact location and identification of the specific fuse. Look for a fuse labeled for the exterior lights or specifically for the license plate lights. If the fuse is blown, replacing it should restore functionality to the license plate lights.
How do you change the license plate light on 2002 Mercury Villager?
The license plate lights are located just above the license plate. Open the tail gate part way to make removal easier (unless you enjoy squatting). Remove the Phillips screws and replace the affected bulb.
