0
put on top dead center on number 1 cylinder(driver side front)and slip dist in hole slowly turning at bottom until it seats all the way down.Make sure rotor is pointing at number 1 not 6 plugwire, if it is raise up a couple inches and turn rotor 180 degrees and set again.very simple to do.
What else can I help you with?
Will a Oldsmobile 350 Distributor fit a Chevy 305 engine?
No
305 Chevy engine timing?
rev the engine to about 2500 rpm's and turn the distributor until you find that sweet spot.
1978 Chevy 305 oil sender location?
It should be in the back of the engine, just to the drivers side of the distributor.
How do you change your distributor from a 305 to a 350?
305 is the same distributor as a 350 will even fit some big block chevy's.
What do you do if timing and distributor are set but engine still backfires 1989 Chevy 305?
maybe check for a worn CAM LOB.
Can a Chevy 305 distributor fit in Chevy 350?
Yes. Its a direct bolt in.
What is the Wire placement on distributor of 305 92 Chevy?
18436572
Where is the cam shaft sensor on a 1997 Chevy 305?
It is in the Distributor.
Will a 305 Chevy distributor fit a 350 block?
yes
Is a Chevy 2.8 engine a 305?
Is a 2.8 liter engine a 305?
How do you install a serpentine belt on a 1994 Z71 305 Chevy engine?
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.
Can you install a 1997 Chevy Suburban 350 V8 engine into a 1997 Chevy C1500 that has a 305 V8 with no mods?
The only one I can think of is the exhaust Y-pipe may not fit from the 305 to the 350.
