nope.
If it is electric windows it is the motor which needs replacing or it could be the regulator
To install the rear window in a 1991 Toyota MR2, first ensure the window and surrounding area are clean. Apply a bead of urethane adhesive to the window frame and carefully position the rear window, aligning it with the frame. Press firmly to ensure a good seal and allow the adhesive to cure as per the manufacturer's instructions. Finally, check for any leaks after the adhesive has set.
The locations of the window adjustment screws will vary between car models. Some cars will require the inner door panel to be removed to get to the adjustments.
If an electric window on a Toyota MR2 goes down, but will not go back up, it has probably slipped off the track. There is a cable mechanism that operates the window. The door panel will have to be removed to repair the cable, or put in a new track.
The power window travel for a 77 Corvette is adjusted by bolts that are in slotted holes. Remove the door panel. Make small adjustments to each adjustment slot until the window travels properly.
The window tracks may have loosened up and are out of adjustment.
In a 2000 Toyota MR2 Spyder, the window relay is located in the fuse box. The fuse box is typically found under the dashboard on the driver's side, near the steering column. You may need to remove a cover to access the relays and fuses. Consult the owner's manual for a diagram to pinpoint the exact location of the window relay within the fuse box.
Begin by removing the Geo Tracker door panel. The entire window mechanism will be visible. The window linkage will have adjustment nuts on each end of the linkage.
I know RX7 FD wheels will fit on a Mk II MR2 but I don't know if the 14" wheels from the '92 MR2 will clear the brake calipers on the RX7.
To adjust the door window on a Volvo C70, first remove the door panel to access the window regulator. Locate the adjustment screws or bolts on the regulator, which control the window's height and alignment. Make small adjustments as needed, then test the window's operation before reassembling the door panel. Ensure that the window moves smoothly and seals properly when closed.
lotus elan