simple use sumthing to cut the belt
it means your alternator is probably gone, and u need to replace it
Remove belt pressure via the tensioning pully. Remove belt from alternator pully. Remove negative battery terminal. Disconnect wiring. Remove bolts. Remove altinator. Replace altinator. Reinstall bolts and connect wiring. Reinstall belt and negative terminal. It should take around 20 minutes.
Disconnect both battery terminals. loosen the alt. bolts, remove the drive belt. then remove the bolts holding thr alt.
The alternator on a 92 Nissan Maxima is changed by disconnecting the wiring harness, loosening the retaining bolts, and removing the drive belt. The bolts can then be fully removed and the alternator swapped out.
To change the alternator on a 1992 Toyota truck, start by disconnecting the negative battery terminal to ensure safety. Remove the serpentine belt by loosening the tensioner, then unbolt the alternator from its mounting brackets. Disconnect the electrical connections from the alternator, install the new alternator, and reconnect the electrical connections. Finally, reattach the serpentine belt and the negative battery terminal.
No.
Not sure if the 92 is the same as the 91, but on the 91 you need to loosen the adjusting idler on the alternator on top and the a/c idler from the bottom. remove the a/c belt & install the alt. belt, make sure your route is correct between the two guide as the belt goes up to the idler... hope that helps.
remove belt then remove two bolts holding it on and remove old put new one on
ya its always 90 to 93
if u cant replace a bulb the u should bring it to a garage .........
90-93
To replace the alternator on a 1992 Chevy Lumina Z34 DOHC, first, disconnect the negative battery cable to ensure safety. Remove the serpentine belt by loosening the tensioner, then unbolt the alternator from its mounting brackets. Disconnect the electrical connections, including the battery and signal wires, and then install the new alternator by reversing the removal steps. Finally, reattach the serpentine belt and reconnect the battery cable.