0
What else can I help you with?
Where do you refill the power steering fluid for a 1986 Toyota Corolla?
You can refill your 1986 Toyota Corolla power steering fluid through the power steering reservoir. The power steering reservoir will be on the left-hand side of the engine.
How do you change the heater core in a Toyota supra 1986?
To change the heater core in a 1986 Toyota Supra, first disconnect the battery and drain the coolant. Remove the dashboard and climate control assembly to access the heater core housing. Disconnect the heater core hoses from the firewall, then unbolt and remove the heater core itself. Install the new heater core, reassemble the housing, dashboard, and reconnect the hoses, ensuring to refill the coolant before testing the system.
How do you add power steering fluid to a 1986 Monte Carlo?
Remove cap to power steering reservoir, add fluid, place cap on reservoir when done.
Why does coolant leak from the back side of the engine of a Toyota pickup 4wd 1986?
Freeze Out plug, cracked block or waterjacket.
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
What does it mean when there is a sweet smell coming from an 1986 Toyota supra?
A sweet smell coming from a 1986 Toyota Supra could indicate a coolant leak, possibly due to a failing head gasket or a damaged radiator. Coolant contains ethylene glycol, which has a sweet odor. It's important to address this issue promptly, as it can lead to engine overheating and further damage if not resolved. Checking the coolant levels and inspecting for leaks should be the next steps.
How do you remove 1986 Toyota Cressida alternator?
To remove the alternator from a 1986 Toyota Cressida, first, disconnect the negative battery terminal to prevent electrical shock. Then, remove the drive belt by loosening the tensioner and sliding the belt off the alternator pulley. Next, disconnect the electrical connections from the alternator and remove the mounting bolts securing it in place. Finally, pull the alternator out of the engine bay.
How do you remove oil pan from 1986 Toyota Cressida?
there are about 12 10mm bolts that hold the oil pan in place. remove them and the pan will drop right down.
1986 Toyota van blower heater relay switch?
you will find it in the heater box, also where the blower is. it is easy to remove.
Do you turn the bolt holding the pulley on the crankshaft clockwise or counter clockwise on a 1986 Toyota pickup?
Counter clockwise to remove.
How do you remove master cylinder reservoir from 1986 Nissan 300zx turbo brake master cylinder?
You will need a large screwdriver or pry bar, some patience, and a good deal of elbow grease. Be careful not to crack the reservoir when prying on it and it will pop off.
Where is Coolant drain 1986 Honda VT1100C?
The bolt to drain the coolant is on the water pump. The water pump is on the left side of the bike, just in front of the oil filter. Just remove the 10mm bolt CLOSEST TO THE OIL FILTER. You'll want to remove the radiator cap prior to doing this so the coolant drains freely. NOTE: Make sure the coolant is cold so you don't get scalded.
