To remove the in-dash air conditioning vent from a 1994 Hyundai Excel, first, disconnect the negative battery cable to ensure safety. Then, use a flathead screwdriver or a trim removal tool to gently pry off the vent cover, being careful not to damage the surrounding dashboard. Once the cover is off, locate and unscrew any screws or clips holding the vent in place, then carefully pull the vent assembly out of the dash. Finally, disconnect any attached wiring or ducts before fully removing the unit.
You don't
To adjust or replace the air-conditioning belt on a 1994 Hyundai Excel, first, ensure the engine is off and cool. Locate the A/C compressor and loosen the mounting bolts to create slack in the belt. If replacing, remove the old belt and thread the new one over the pulleys, ensuring it is properly aligned. Finally, adjust the tension by repositioning the compressor, then tighten the mounting bolts and check the belt tension before starting the engine.
A fuse box diagram for a 1994 Hyundai Excel is found on the fuse box itself. Underneath the cover of the fuse box will be a sticker labeling all the fuses.
i have a 1994 excel and i use 4 quarters of synthetic oil
it is 1 3 4 2
i have an excel 1994 and originally it was automatic, but it has a Mitsubishi mirage transmission.
The 1994 Hyundai Excel typically weighs around 2,300 to 2,500 pounds, depending on the specific model and trim level. This compact car was designed for fuel efficiency and practicality, contributing to its relatively light weight.
Gently pry up on the speaker cover with a small screwdriver or knife. There are screws under the cover to remove the speaker, unplug harness and its free.
To remove the stock radio from a 1994 Hyundai Excel, first, disconnect the negative battery terminal to ensure safety. Then, use a flathead screwdriver to gently pry off the trim panel surrounding the radio. Once the trim is removed, unscrew the mounting screws securing the radio in place, and carefully slide the radio out of the dashboard. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
underneath the engine to the right when looking at it with fan belt facing you.
Honestly? At the junkyard, or on eBay.
change the valve stem seals