To remove the rear bumper cover on a 2001 Lexus RX 300, start by removing the screws and clips securing the bumper to the vehicle, usually found in the wheel wells and along the underside. Next, detach any electrical connectors for rear lights if applicable. Carefully pull the bumper away from the vehicle, ensuring not to damage any retaining clips. Finally, lift the bumper off the mounting points to completely remove it.
== == == == you don't it's molded int to the bumper.
what other year mitsubishi galant rear bumper cover is compatable with a 2001 cover?
you need to remove the bumper cover to access the horn. The horns at below to the out side of the head lights
you have to remove the bumper
Bumper cover or fascia.
On my 2000 grand cherokee, It was in front of the battery on the fender wall. Remove battery and you should find it. It is under the bumper cover, under the passenger head light. You either have to remove the front bumper, or you remove the headlight and cut an access hole.
2001-2002 I know the screws are behind the trunk panel. Two on each side I think and the ones in the back.
Take it out
take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
The horn is located in front of the right tire. You have to remove the plastic cover in front of the tire to get to it. You should be able to see it through the vent on the front bumper.
Very carefuly.
To remove the front bumper from a 2001 Ford Ranger, start by disconnecting the negative battery cable for safety. Next, remove any screws or bolts securing the bumper to the frame, typically located at the top and bottom of the bumper. You may also need to remove any plastic clips or fasteners. Finally, carefully pull the bumper away from the vehicle, ensuring you detach any wiring for lights if applicable.